Sealey RE012 User Manual
Re012, Air suction dent puller, Model n
WARNING! Ensure Health & Safety, local authority and general workshop practice regulations are adhered to when using
this equipment.
Maintain the puller in good condition (use an authorised service agent). Before each use check condition of tool. If any
component is worn or damaged, replace immediately. Use genuine parts only. Unauthorised parts may be dangerous and
will invalidate the warranty.
DO NOT operate the puller if any parts are damaged or missing as this may cause failure and/or personal injury.
Use in a suitable work area. Keep area free from unrelated materials and ensure that there is adequate lighting.
WARNING! Always wear approved eye (or face) and hand protection when operating the puller.
Remove ill fitting clothing, ties, watches, rings, other loose jewellery and contain and/or tie back long hair.
DO NOT attempt to attach the suction cup to a person as severe bruising and/or damage to internal organs can occur.
Maintain correct balance and footing.
DO NOT over reach, ensure the floor is not slippery, wear non-slip footwear.
Keep children and unauthorised persons away from the working area.
Ensure workpiece is secure before operating the puller.
DO NOT operate the puller when you are tired or under the influence of alcohol, drugs or intoxicating medication.
DO NOT clean the suction cups with solvents or other harsh chemicals.
DO NOT use the puller for any purpose other than that for which it is designed.
When not in use return parts to the case, and store it in a safe, dry, childproof location.
InStRUctIonS foR:
AIR SUCTION DENT PULLER
ModEl n
o
:
RE012
thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly
maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/
OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
2. DESCRIPTION
A versatile suction dent puller fitted with an integral manual vacuum pump and red line indicator. A selected suction pad keeps firm
hold of panel while slide hammer is used to ease out dents and depressions without damage to the paint surface. Ideal for initial
panel reshaping. Supplied with Ø75mm, Ø100mm and Ø125mm suction pads and hook.
Original Language Version
RE012 Issue: 1 - 20/09/12
© Jack Sealey limited
Ø100mm Suction cup
Ø125mm Suction cup
3. CONTENTS
Ø75mm Suction cup
dent puller hook (90mm long)
Vacuum pump and sliding
hammer assembly (o/a length 730mm)
carry and storage case