Sealey RE97XC02 - Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
2. CONTENTS/SPECIFICATION
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
p p WARNING! Ensure Health & Safety, local authority and general workshop practice regulations are adhered to when using this equipment.
3 Familiarise yourself with product application and limitations, as well as the specific hazards peculiar to the kit.
p p WARNING! Disconnect the ram from the hydraulic pump before servicing or performing any maintenance on the unit.
3 Maintain kit in good order. Replace/repair with genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
3 Use qualified person to lubricate and maintain the ram.
3 Keep the repair kit clean for best and safest performance.
p p WARNING! Ensure you know how much load you are pushing/pulling. Never exceed the maximum pushing/pulling capacity.
3 Use only with Sealey hydraulic pump and accessories. Wrong equipment may damage unit and invalidate your warranty.
3 The kit accessories may be used with other popular makes of kit.
3 We recommend the use of BS approved safety impact goggles and heavy duty gloves when working with this kit. Both are available from your
authorised Sealey dealer.
3 Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
3 If working on an ‘off centre’ load, pump with care. If you feel undue resistance, stop and re-adjust the set-up.
p p WARNING! Keep your hands, body and clothing away from the kit and accessories when in use. Take any necessary
precautions to protect your personal safety whilst using the repair kit.
Always be prepared for unexpected load movement, never place yourself or any part of your body in a position that could result in
injury. Always use a crowbar or similar device to manoeuvre the load.
3 Ensure the hydraulic hose is not bent or kinked but laid out correctly. Avoid damage to the hose (e.g. crushing/cutting).
3 Keep non-essential persons away from the operating area. Be aware of the locations of other persons assisting you.
3 When releasing tension from the load be sure to undo the hydraulic valve VERY slowly.
7 DO NOT operate the kit if any parts are damaged or missing as this may cause failure and/or personal injury.
p p WARNING! DO NOT use for any purpose other than for that which it is designed.
7 DO NOT heat accessories as this may weaken them.
7 DO NOT modify accessories for use with this kit.
3 When not in use, place dust cap in end of hydraulic hose and store the kit, in the case, in a safe, dry, childproof location.
Only fully trained and qualified persons should use this equipment. These instructions are not a substitute for user receiving full
supervised training by a qualified person. It is important the user understands the applications, limitations and potential hazards of the product.
RE97XM10
RE97XMO4
RE97XCO2
RE97XC10
RE97XCO4
RE97XMO2
RE97XCKIT
RE97XMO5
RE97XCKIT - 1 - 051104
INSTRUCTIONS FOR:
SPECIALIST PUSH AND PULL RAM SET
Model: RE97XCKIT
Ram Model No. Type. Capacity. Closed /Open Height. Return Spring
RE97XC02 . . . . .Push . . . .2000kg . . . . . . .139/240mm . . . . . . . . .No
RE97XC04 . . . . .Push . . . .4000kg . . . . . . . . .42/58mm . . . . . . . . .No
RE97XM04 . . . . .Push . . . .4000kg . . . . . . .275/405mm . . . . . . . . .Yes
RE97XC10 . . . . .Push . . .10000kg . . . . . . .132/189mm . . . . . . . . .Yes
RE97XM10 . . . . .Push . . .10000kg . . . . . . .350/500mm . . . . . . . . .Yes
RE97XM02 . . . . . .Pull . . . .2000kg . . . . . . .422/550mm . . . . . . . . .Yes
RE97XM05 . . . . . .Pull . . . .5000kg . . . . . . .520/650mm . . . . . . . . .Yes
Hook Model No.
RE97XM02.H 2Ton Pull Ram 2000Kg
RE97XM05.H 5Ton Pull Ram 5000Kg