Sealey RE83/840 - Manual

INSTRUCTIONS FOR:
AIR HYDRAULIC PUMP 10TONNE
MODEL Nos:
RE83/840.v2 & RE83/840/CWH.v2
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INvALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

WARNING! Ensure Health & Safety, local authority and general workshop practice regulations are adhered to when using this equipment.

Familiarise yourself with product application and limitations, as well as the specific hazards peculiar to the pump.

WARNING! Disconnect the hydraulic pump from the apparatus before servicing or performing any maintenance.

Maintain pump in good order. Replace/repair with genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.

Use qualified person to lubricate and maintain the hydraulic pump. DO NOT use brake fluid to top up hydraulic unit. Use Sealey hydraulic oil only.

Keep the pump and treadle clean for best and safest performance.

WARNING! Ensure you know how much load you are pushing. Never exceed the maximum pushing capacity.

The kit accessories may be used with other popular makes of kit.
 We recommend the use of BS approved safety impact goggles and heavy duty gloves when working with this pump. Both are available from your
authorised Sealey dealer.

Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.

If working on an ‘off centre’ load, pump with care. If you feel undue resistance, stop and re-adjust the set-up.

Ensure any hydraulic hoses are not bent or kinked but laid out correctly. Avoid damage to hoses (e.g. crushing/cutting).
 Keep non-essential persons away from the operating area. Be aware of the locations of other persons assisting you.

DO NOT operate the pump if any parts are damaged or missing as this may cause failure and/or personal injury.

WARNING! DO NOT use for any purpose other than for which it is designed.

When not in use, place dust cap in end of hydraulic hose or cylinder and store in a safe, dry, childproof location.
Only fully trained and qualified persons should use this equipment. These instructions are not a substitute for user receiving full
supervised training by a qualified person. It is important the user understands the applications, limitations and potential hazards
of the product.
Original Language Version RE83/840.V2 & RE83/840/CWH.V2 Issue: 2(P) - 01/03/13
MODEL: RE83/840.V2
MODEL: RE83/840/CWH.V2
© Jack Sealey Limited 2013
2. INTRODUCTION/SPECIFICATIONS
2.1 Suitable for use with SuperSnap hydraulic ram as supplied with Model No. DZRE92/C body straightener and all body kits.
Air Supply Oil Pressure Oil Capacity Hose
Model No. RE83/840.V2 90-120psi 10000psi 450cc not supplied
Model No. RE83/840/CWH.V2 90-120psi 10000psi 450cc supplied (loose)
R