Sealey SM1301 - Manual (Page 3)

4. OPERATING INSTRUCTIONS 5. MAINTENANCE
5.1. Clean regularly using a vacuum cleaner and brush.
5.2. Check machine for defects before every operation.
5.3. Check operation of emergency stop before each use.
5.4. Have the machine regularly serviced by an authorised service agent.
4.1. Ensure that you have read, understand and apply the safety instructions in Section 1.

WARNING! Before use, the machine must be positioned on a stable, fireproof bench or table which is strong enough to take
the weight of the machine and the workpiece. Failure to comply with this instruction could result in severe personal injury.

WARNING! Before each use rotate the bobbin by hand to check it is undamaged and secure.
Remove any spanners before turning the machine on. Ensure you wear approved safety goggles, gloves, ear defenders and,
if the machine generates dust, respiratory protection.

WARNING! DO NOT switch the machine on whilst the workpiece is in contact with the bobbin.
4.2. Table adjustment
4.2.1. The table is adjustable through 45O by slackening the two thumb screws on either side of the table and moving the table to the
desired position on the degree plate. Re-tighten the thumb screws.
NOTE! When using the table at an angle ensure you use the insert with the oval hole.
4.3. Starting Sander
4.3.1. The SM1301 is fitted with a No-Volt switch. In the event of a power failure the machine will not start once the power is restored.
4.3.2. The ON/OFF button is located on the front of the machine and incorporates the emergency stop button.
4.3.3. Press the green button to start.
4.3.4. To turn off simply push the emergency stop button, there is no need to lift the cover to access the red stop button.
4.4. Using the SM1301
4.4.1. The bobbins spins clockwise as you look from the front of the machine.
4.4.2. Feed the workpiece across and with the direction of the rotation.
CAuTION! Never stand with your body directly behind the workpiece, the machine could force the workpiece into the
operator and cause serious injury.
4.5. Using Table at Angle
4.5.1. Remove the round insert and store. Place the oval insert in the table ensuring it is the correct size to suit the bobbin.
4.5.2. Tilt the table to the desired angle.
4.5.3. Feed the work into the machine following the direction of rotation.
NOTE! When the table is tilted the workpiece must be run parallel to the bobbin for the angle to remain constant.
4.6. Dust Extraction
4.6.1 The SM1301 is fitted with a 50mm extraction outlet which should be connected to a suitable extractor.
4. OPERATING INSTRUCTIONS
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
email
Original Language Version SM1301 Issue: 2 - 23/03/10