Sealey TC414 - Manual

Fig.1. Fig.2. Fig.3. Fig.4. A
INSTRUCTIONS FOR:
TILE CUTTERS
Model Nos
: TC314, TC414, TC4163
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND/OR CAUTIONS. USE THIS
PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE OR PERSONAL INJURY
AND WILL INVALIDATE THE WARRANTY. PLEASE RETAIN THESE INSTRUCTIONS FOR FUTURE USE.
TC314, TC414, TC4163 - 1 - 060302
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will give you years of trouble free performance if these instructions are carefully followed and the
product is correctly maintained.
1. SAFETY INSTRUCTIONS
p WARNING! DO NOT cut any materials containing asbestos.
p WARNING! Before each use check cutting disc is not worn or damaged, if so replace immediately. Use genuine parts only. Unauthorised
parts may be dangerous and will invalidate the warranty.
p WARNING! The cut edge of the workpiece will be very sharp.
p WARNING! Cut tiles can produce very sharp shards of glazed ceramic.
8 DO NOT force the tile cutter to achieve a task it was not designed to perform.
8 DO NOT use the tile cutter for any purpose other than for which it is designed.
8 DO NOT allow children to operate the tile cutter.
8 DO NOT operate the tile cutter if any parts are damaged or missing as this may cause failure and/or possible personal injury.
8 DO NOT over press on the down handle in order to etch the glaze. Maintain a controlled adequate progression, which will ensure an even score
through the glaze and avoid unnecessary wear on the blade.
3 Avoid subjecting the operating handle to excessive strain, always ease the handle down against workpiece (a harsh downward impact may
break the tile).
3 Wear safety eye protection.
3 Remove personal items such as bracelets and necklaces, remove ties and contain long hair.
3 When not in use store in a safe, dry, child proof area.
2. INTRODUCTION & SPECIFICATIONS
2.1. Introduction.
A range of heavy gauge steel sheet based tile cutters with foam tile cushioning, measuring scale and replaceable Tungsten Carbide cutting
wheel. The TC414 has an adjustable stop. The TC4163 has an adjustable stop, an adjustable measuring scale with stop allowing cutting
between 0-45° and includes a cutting attachment for making holes 30-80mmØ.
TC314 TC414 TC4163
2.2. Specifications
TC314 TC414 TC4163
Base Size (mm) 435 X 140 595 X 165 700 X 205
Cutting Length (mm) 300 430 450
Cutting Thickness (mm) 12 14 16
3. OPERATION
3.1. Tile Cutting.
3.1.1. Mark the glazed surface of the tile with the required position of the cut.
3.1.2. Place the tile on the cushioned bed of the tile cutter and position firmly against the measuring scale. Align the required position of the
cut with the cutting wheel and hold the tile firmly in place. Apply sufficient pressure to the handle, in order to etch the glaze, whilst
drawing the cutting wheel across the surface of the tile, fig.1.
3.1.3. Position the breaker foot at the beginning of the cut, grip the handle and guides and apply sufficient downward force on the handle to
break the tile, figs.2 & 3.
3.1.4. Remove the cut tile from the cushioned bed, fig.4. Note: The cut edge will be sharp.