Sealey VS0042 User Manual
Vs0042, Model no
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
2. INTRODUCTION & SPECIFICATION
Follow workshop Health & Safety rules, regulations and conditions when using this equipment.
WARNING! Disconnect from air supply before changing accessories or servicing.
Maintain the
equipment in good condition and replace any damaged or worn parts. Use genuine parts only. Unauthorised parts may be
dangerous and will invalidate the warranty.
WARNING! Check that correct air pressure is maintained and DOES NOT exceed 100psi.
Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each use and ensure that all connections are secure.
Wear approved safety gloves and eye and ear protection.
Keep VS0042 clean and in good working order for best and safest performance.
DO NOT use the VS0042 for a task it is not designed to perform.
WARNING! DO NOT use VS0042 if damaged or thought to be faulty. Contact your local service agent.
DO NOT drop, throw or abuse the VS0042.
DO NOT carry the VS0042 by the air hose, or yank the hose from the air supply.
DO NOT operate the VS0042 if you are tired or under the influence of alcohol, drugs or intoxicating medication.
DO NOT direct air from the air hose at yourself or others.
Keep children and unauthorised persons away from the work area.
When not in use disconnect from air supply and store in a safe, dry, childproof location.
WARNING! The warnings, cautions and instructions referred to in this instruction manual cannot cover all possible conditions and situations that
may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied by
the operator.
INSTRUCTIONS FOR:
COOLING SYSTEM VACUUM PURGE AND
RE-FILL KIT
Model No:
VS0042
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you years of trouble free
performance.
Dramatically reduces cooling system refill time, without mess and without introducing air-locks. No more time consuming cooling system bleeding
and no more messy spills to clean up. Simply plug into the workshop air line, attach to the cooling system header tank and create a vacuum.
Complete the process by attaching the filler hose and opening the valve allowing your pre-mixed coolant to flow into the system. Supplied with 3
adaptors and carry-case.
Recommended hook-up is shown below.
WARNING! Ensure that the air supply is clean and
does not exceed 100psi. Too high an air pressure
or unclean air will shorten the life of the filler, due to
excessive wear, and may be dangerous, causing
damage and/or personal injury.
3.1. Drain the air tank daily.
3.2. Clean compressor air inlet filter weekly.
3.3. Keep hose away from heat, oil and sharp edges.
Check hose for wear and make certain that all
connections are secure.
3. AIR SUPPLY
Air Pressure (max) . . . . . . . . . . . . . . .100psi (6.9 bar)
Air Pressure (min) . . . . . . . . . . . . . . . . .80psi (5.5 bar)
VS0042 Issue No: 1 - 10/07/08