Sealey AK716 - Manual

INSTRUCTIONS FOR
BLIND BEARING PULLER SET 12PC
MODEL NO:
AK716.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1. GENERAL SAFETY
R WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this tool.
R WARNING! Familiarise yourself with the specific applications and limitations of the kit, as well as any potential hazards.
 This kit should be used in conjunction with inspection maintenance procedures recommended in the vehicle manufacturer’s manual.
 Ensure that the kit is correct for the task.
 Wear the appropriate personal protective equipment for the task. A full range is available from your Sealey dealer.
 DO NOT use the kit for any purpose other than that for which it is designed.
 Ensure that the vehicle is properly supported with axle stands before working under the vehicle.
 Ensure there is adequate lighting prior to using the kit. A range of inspection lamps are available from your Sealey dealer.
 Keep children and unauthorised persons away from the working area.
 DO NOT use the kit if any parts are damaged or missing, as this may cause failure and/or personal injury.
 DO NOT use the kit when you are tired, or under the influence of alcohol, drugs or intoxicating medication.
 After use, store in a safe, dry childproof area.
2. INTRODUCTION
Medium stroke 1.5kg slide hammer with 395mm shaft and a screw type bridge extractor. Gently removes blind bearings where the use of a slide
hammer may damage the surrounding material. Includes bearing extractor collets with internal capacity from 8 to 34mm. Supplied in carry-case.
3. SPECIFICATION
Model No:. .............................................................AK716.V2
Collet Ø: ...... 8-9.4, 9.5-11.4, 11.5-13.4, 13.5-16.4, 16.5-18.4,
........................................18.5-24, 24.5-29.5, 30-32.5, 33-34.
4. CONTENTS
AK716.V2 | Issue 1 03/03/15 Original Language Version © Jack Sealey Limited
Refer to
Instruction
Manual
Wear eye
Protection
Wear
Protective
Gloves
Item Part Number Description
1 AK716.V2-01 Slide hammer
2 AK716.V2-02 Collet 20-22mm + Drive pin 13mm (long)
3 AK716.V2-03 Collet 8-9.5mm + Drive pin 13mm (short)
4 AK716.V2-04 Collet 10-11mm + Drive pin 10mm
5 AK716.V2-05 Collet 12-13.5mm
6 AK716.V2-06 Collet 15-16mm
7 AK716.V2-07 Collet 17-18.5mm
8 AK716.V2-08 Collet 25-27mm
9 AK716.V2-09 Collet 30-32mm
10 AK716.V2-10 Collet 32-33.5mm
11 AK716.V2-11 Drive pin 13mm
12 AK716.V2-12 Puller Assembly