EnGenius Technologies DURAFON-1X - Manual (Page 12)

~23~
Notes:
1. After a link established, the Base ID will appear on the upper-
right corner. If no Base ID show up, it applied that you are
approaching the boundary of the coverage.
2. If the line is occupied, the LCD shows “No Line Available”
and handset returns to standby mode.
3. If a link cannot be established, the LCD will show “No Base”
after a 12-second time out.
4. A call duration timer will start displaying the length of the call
after link is established.
Making a 2-Way/ Intercom Call
The EnGenius Industrial Cordless Phone System offers private, Intercom/ 2-
way radio calls independent of the base station. Intercom/ 2-way
communication can be placed from or to base stations and handsets.
A. Handset to Handset Calls
1. Press Intercom key followed by a two-digit handset
ID or Group ID.
2. Press END key to end the call.
Notes:
1. Intercom calls can be made regardless if the Base Station is
present.
2. If a Group ID is entered, the first handset (belonging to that
group) that answers will establish a link with the caller. See
Handset Group Subscription.
3. If a link cannot be established, the LCD shows “No
Connection” after a 12-second time out.
B. Intercom/2-Way from Base to Handset
1. Press Intercom key on the base station to intercom
all registered handsets. The first handset to answer
will establish a voice link with the base.
2. The INTERCOM LED will flash until a handset
responds.
3. The base unit will page for 15 seconds, then terminate the page if no
handset responds.
4. Before a handset answers, the INTERCOM can be cancelled from the
­ 11
Please enter
Ext. #: 12
­ 11
Intercom from
Base 1
SLIENT
~24~
base by pressing INTERCOM again. However, once a handset answers,
only the answering handset can end the call.
C. Intercom/2-Way from Handset to Base
1. Press Intercom key followed by a two-digit base ID.
[Note: Base 1 ID as 10, Base 2 ID as 20, Base 3 ID
as 30, and Base 4 ID as 40]
2. The base will ring once, then automatically connect
the intercom call from a handset.
Making a Broadcast
A. Handset to Handset Calls
1. Broadcasting
all handsets
a. Press “BROADCAST” key from one handset.
b. After hearing bi-bi-beep signal; begin broadcast
message.
c. All related handsets, within communication
range of initiating handset, will receive the
broadcast.
d. Press END key to end the broadcasting.
2. Broadcasting a group of handsets
a. Enter the Group ID and then press
“BROADCAST” key.
b. After hearing bi-bi-beep signal; begin broadcast
message.
c. All related handsets, within group and within
communication range of initiating handset, will
receive the broadcast.
d. Press END key to end the broadcasting.
3. Broadcasting an individual handset
a. Enter the Handset ID and then press
“BROADCAST” key.
b. After hearing bi-bi-beep signal; begin broadcast
message.
c. The related handset, within communication
range of initiating handset, will receive the
broadcast.
d. Press END key to end the broadcasting.
­ 11
Please enter
Ext. #: 10
­ 11
PA paging
to all…
­ 11
PA paging
to Ext. # 02
­ 11
PA paging
to Ext. # 12