Sealey VS019 - Manual

Thankyou for purchasing this Sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
Important: Read these instRuctions caRefully. use this clutch aliGnMent tool coRRectly and With caRe foR the
PuRPose foR Which it is intended. failuRe to do so May cause daMaGe oR PeRsonal injuRy and Will invalidate the
WaRRanty. Retain these instRuctions foR futuRe use.
2. sPecification
1. safety instRuctions
 WaRninG! Ensure that Health and Safety, local authority and general workshop practice regulations are adhered to when
using this tool.
 do not use this tool if damaged.
 Maintain tool in a good and clean condition for best and safest performance.
 Ensure that the ignition key is removed, to prevent inadvertent engine cranking.
 If the vehicle to be worked on is raised, ensure that it is adequately supported with axle stands or ramps and chocks.
 Wear suitable clothing to avoid snagging. do not wear loose jewellery and tie back long hair.
 Account for all tools and parts being used.
 If working off the vehicle, ensure that the workpiece is secure and stable.
 do not use the alignment tool if you are tired or under the influence of alcohol, drugs or intoxicating medication.
iMPoRtant: Always refer to the individual vehicle manufacturer’s service instructions, or a proprietary manual, to
establish the correct procedure and data for the use of this tool.
this document is provided as a guide only.
An essential tool designed to test the condition of a Dual Mass Flywheel (DMF). Use with the DMF fitted to the vehicle and
with the gearbox/clutch removed. Fitting a new clutch with a faulty DMF may result in early failure of the new clutch. Results
may be checked against the vehicle manufacturer's specification.
INSTRUCTIONS FOR:
dual Mass flyWheel MeasuRinG tool
Model No : vs019
VS019 ISSUE No:1 - 20/06/13
3. contents
Refer to picture below
Slotted Bar (1)
Slotted Bar Adapters x 6 (M6x1.0, M7x1.0, M8x1.25 two of each) (2)
Angular Torque Gauge (3)
DTI Gauge (shown without its box) (4)
DTI Gauge Bracket Including Mounting Plate (5) and Retaining Bolt (6)
Ring Gear Locking Tools x 2 (7)
Original Language Version © Jack Sealey Limited