Sealey GA450 User Manual
Page 2
01284 757500
01284 703534
Sole UK Distributor
Sealey Group,
bury st. edmunds, suffolk.
www.sealey.co.uk
Web
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our catalogue and latest promotions call us on 01284 757525 and leave your full name, address and postcode.
3. MEASURING CAMbER ANGLE
4. MEASURING CASTOR ANGLE
5. MEASURING KINGPIN INCLINATION
NOTE! Before use remove magnet protective plate.
Replace after use.
3.1
Drive vehicle forwards to centralise wheels.
3.2
fit gauge in centre of vehicle wheel/hub.
3.3
set D bubble to centre and read the position of a
bubble.
NOTE! Refer to the owner’s handbook before making any
adjustments.
NOTE! Any adjustments you make to either castor or
camber angles may affect the other, so re-check all
measurements after any adjustments have been made.
NOTE! Try to simulate normal running conditions, ie. half a
tank of fuel and a weight similar to the driver in the front
seat.
4.1 Drive vehicle forward so front wheels are positioned on
steering turntables in the straight ahead position, rear
wheels on level plates.
4.2 turn the front wheel to 20° out.
4.3 fit gauge in centre of wheel/hub and set D bubble to
centre.
4.4 set b bubble to 0 with adjusting screw and turn the
front wheel to 20° in.
4.5 set D bubble to centre again and read the scale of b
bubble.
NOTE! Refer to the owner’s handbook before making any
adjustments.
NOTE! Any adjustments you make to either castor or
camber angles may affect the other, so re-check all
measurements after any adjustments have been made.
We recommend the use of turntables Model No. GA44
when checking the caster as this will enable you to
accurately set the wheels at 20°
5.1 Drive vehicle forward so front wheels are positioned on
steering turntables in the straight ahead position, rear
wheels on level plates.
5.2 turn the front wheel to 20° out.
5.3 fit gauge in centre of wheel/hub and set D bubble to
centre.
5.4 set c bubble to 0 with adjusting screw and turn the
front wheel to 20° in.
5.5 read scale of c bubble.
NOTE! Refer to the owner’s handbook before making any
adjustments.
ga450 Issue no: 1 - 28/10/08