Sealey VS1273 - Manual

Thankyou for purchasing this Sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
Important: Read these instRuctions caRefully. note the safe oPeRational ReQuiReMents, WaRninGs and cautions.
use this tool coRRectly and With caRe foR the PuRPose foR Which it is intended. failuRe to do so May cause daMaGe
oR PeRsonal injuRy and Will invalidate the WaRRanty. Retain these instRuctions foR futuRe use.
2. intRoduction 1. safety instRuctions
INSTRUCTIONS FOR:
ReaR huB PulleR foRd tRansit
MODEL NO: vs1273

WaRninG! Ensure Health and Safety, local authority
and general workshop practice regulations are
adhered to when using tools.
 Observe standard workshop safety procedures.

WaRninG! Take extreme caution when using these
tools, components are heavy. Ensure the snap lock
chain is employed.
 Maintain correct balance and footing. do not over
reach, ensure the floor is not slippery, wear non-slip
toe protector shoes.
 Remove loose fitting clothing, ties, watches, rings,
loose jewellery, and contain or tie back long hair.
 Wear approved eye protection, gloves and footwear.
A range of personal safety equipment is available
from your Sealey dealer.
 do not use these tools for any purpose other than
those for which they have been designed.
 do not use tools if damaged.
 Maintain tools in good and clean condition for best
and safest performance.
 Ensure that a vehicle which has been jacked up is
adequately supported with axle stands.
 Remove appropriate road wheels and brake calipers.
 do not attempt to start engine or move vehicle
whilst in gear with tools fitted.
 Account for all tools and parts being used and do not
leave them in or near the engine.

iMPoRtant: These instructions are provided as a
guide only. Always refer to the vehicle manufacturer’s
service instructions, or a proprietary manual, to
establish the current procedure and data.
 When not in use, clean and store the tools in their
case in a safe, dry, childproof location.
Engineered for safe removal of rear hubs on front wheel drive
Ford Transits. Fixes onto the vehicle wheel studs. Features
a cleverly designed impact force screw for the separation of
the hub from the stub axle. Supplied with snap hook chain for
added safety.
Original Language Version VS1273 Issue: 1 - 06/03/14 © Jack Sealey Limited
1
2
3
4
5
6
3. sPecification/contents
Item Sealey Part No. Description Qty
1 VS1273.01 Adaptor flange 1
2 VS1273.02 Ram 1
3 VS1273.03 Force screw barrel 1
4 VS1273.04 Snap ring 1
5 VS1273.05 M16 Nuts & Washers 5 sets
6 VS1273.06 Snap lock chain 1 length
7 VS1273.07 M8 Screw 1
• Application Ford Transit 2000 onwards.
• Front wheel drive vehicles only.
• OEM 204-595-09
fig.1
7