Sealey VS715 User Manual
Sealey Tools
INSTRUCTIONS FOR:
CV JOINT THREAD CHASER 8pc
MODEL No.
VS715.V2
1.1. GENERAL SAFETY
p
WARNING! Ensure health & safety, local
authority, and general workshop practice
regulations are adhered to when using this
equipment.
8
DO NOT hold the workpiece by hand.
Use clamps or a vice (not included) to secure
the workpiece.
3
Wear approved safety eye protection
(standard spectacles are not adequate).
3
Keep the work area clean, uncluttered and
ensure there is adequate lighting.
3
Keep children and unauthorised persons
away from the working area.
1.2. PERSONAL PRECAUTIONS
3
Remove ill fitting clothing. Remove ties,
watches, rings, and other loose jewellery,
and contain and / or tie back long hair.
3
Ensure that a vehicle which has been jacked
up is adequately supported with axle stands
and that the wheels are chocked.
DO NOT use air tools.
Repairs light damage to CV joint threads. Set contains sizes to fit the most common types of
vehicle. Must be used with a light oil to lubricate thread. Supplied in storage case.
1. SAFETY INSTRUCTIONS
2. INTRODUCTION & SPECIFICATION
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these
instructions and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
Contents:
M20 x 1.25, M20 x 1.5, M22 x 1, M22 x 1.5, M24 x 1.5, M24 x 2mm.
(UNEF - Extra Fine Pitch) 3/4” x 20 UNEF, 13/16” x 20 UNEF.
ALWAYS KEEP THREADS
WELL LUBRICATED WITH A LIGHT
OIL.
DO NOT USE AIR TOOLS
M24X1.50
SEALEY
Original Language Version
VS715.V2 Issue: 1 - 04/12/13
© Jack Sealey Limited