Sealey SSP155DX User Manual

Safety instructions 2. application

Advertising
background image

INSTRUCTIONS FOR
DISPOSABLE WELDING MASK
MODEL: SSP155DX.V2

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions

and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL

REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE

PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL

INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

1. SAFETY INSTRUCTIONS

2. APPLICATION

2.1 The filtering half mask SSP155DX has been approved according to EN149 as an FFP2S respirator.

When worn properly and given adequate care, SSP155DX provides excellent protection against the

hazard of welding fumes. The mask provides protection subject to the concentration of the contaminant

being no more than 10 times the recommended

Occupational Exposure Limit.

1.1. GENERAL SAFETY

WARNING! Put the mask on before entering an area containing airborne contaminants and

wear at all times during exposure in a contaminated atmosphere.

This mask does not supply oxygen. Use only in adequately ventilated areas containing

sufficient oxygen to support life.

The mask does not protect the user against radioactive particles, viruses and enzymes.

Before use, check that the mask will provide the required level of protection in the environment in which

it is to be used.

Inspect the mask to ensure there are no tears or snags and that it is in good condition.

Discard the mask after single use.

DO NOT use the same mask for more than 8 hours.

DO NOT use when concentrations of contaminants are unknown or immediately dangerous to health or

life.

DO NOT alter or modify this mask in any way.

1.2. PERSONAL PRECAUTIONS

Ensure there is another person within sight close enough to come to your aid should a problem arise

when working.

Leave the work area immediately and return to fresh air if breathing becomes difficult, or if

dizziness or other signs of distress occur.

Advertising