Sealey ATL13 User Manual

Aluminium telescopic ladders, Instructions for, Safety instructions

Advertising
background image

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions

and properly maintained, give you years of trouble free performance.

1. SAFETY INSTRUCTIONS

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.

USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE

DAMAGE OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

2. INTRODUCTION

2.1 Introduction

Extends and locks rung by rung allowing use at multiple heights. Fold down finger guards ensure that hands cannot get trapped while

ladder is lowered. Closed heights range of 795mm (ATL07), 875mm (ATL09), 880mm (ATL11) and 1010mm (ATL13) for easy storage

and transportation make this ideal for surveyors, tradesmen and domestic use. Lightweight, corrosion resistant aluminium frame. Rubber

feet offer increased stability while in use. Manufactured to BS EN 131 with 150kg capacity.

Model No:

ATL07

ATL09

ATL11

ATL13

Treads:

7

9

11

13

Minimum Height:

795mm

875mm

880mm

1015mm

Maximum Extension:

2090mm

2690mm

3215mm

3870mm

Maximum Capacity:

150kg

150kg

150kg

150kg

Weight:

5.5kg

8kg

10.5kg

13kg

ATL07, ATL09, ATL11, ATL13 Issue: 1 - 08/12/11

INSTRUCTIONS FOR:

ALUMINIUM TELESCOPIC LADDERS

MODEL No's.

ATL07, ATL09, ATL11, ATL13

1.1. GENERAL SAFETY.

DANGER! Take care when using and moving extended ladders in the vicinity of power cables - risk of potentially fatal electric

shock.

WARNING! Ensure Health and Safety, local authority, and general workshop practice regulations are adhered to when using this

equipment.

Familiarise yourself with the application and limitations of the ladder, as well as the potential hazards.

Maintain the ladder in good condition.

Keep the work area clean, uncluttered and ensure there is adequate lighting.

WARNING! Use ladder on level and solid ground and either have an assistant stand on the lowest rung or otherwise anchor the base

of the ladder to prevent slipping. Ensure that the surface the ladder is standing on is able to support both the weight of the ladder and

yourself.

WARNING! DO NOT use the ladder on sloping ground. When viewed from the front, the top of the ladder section(s) must always

be directly above the base.

DO NOT use the ladder on a wet floor surface, or a floor surface contaminated with oil or similar substances.

For stability, place the ladder so that it is at an angle of 65° to 75° to the ground, the foot of the ladder should be 1 metre from the wall for

every 3 metres of elevation.

Where possible, attach top of ladder to a fixture to prevent slipping.

WARNING! Never over-reach when on the ladder, keep close to the centre line of the ladder.

Keep children and unauthorised persons away from the working area and

DO NOT allow children to climb the ladder.

DO NOT use the ladder for any purpose other than that for which it is designed.

DO NOT use the ladder if it is damaged or any parts are missing, as this may cause failure and/or personal injury.

DO NOT exceed the rated weight capacity of the ladder.

DO NOT climb higher than the second rung from the top of the ladder.

DO NOT use the ladder when you are tired or under the influence of alcohol, drugs or intoxicating medication.

Take care when lowering the ladder, ensuring that hands are kept clear of the rungs.

Wear slip resistant footwear, and ensure that the footwears' soles and the rungs of the ladder are free of oil or similar substances.

Hold on to the ladder at all times when climbing.

When not in use, ensure ladder is fully retracted and store in a safe, dry, childproof location.

3. SPECIFICATION

4. INSTRUCTIONS FOR USE

4.1 Locking Mechanism (Fig.1)

4.1.1 The ladder locks every section with two steel locking levers that spring into place when the

ladder is extended. When the section is securely locked into place, the levers will be

positioned towards the outer edges of the rung.

4.1.2 When retracting the ladder slide both the levers towards the centre to release the section

(refer to Section 4.4).

WARNING! Ensure that all locks are fully engaged into their locking positions before

using the ladder.

Fig.1

Advertising
This manual is related to the following products: