Sealey CP2518 - Manual (Page 3)

6. MAINTeNANce
6.1. Always store the polisher on its side so that the foam pad does not become compressed and/or distorted.
6.2. remove bonnet when not in use to allow foam pad to dry out.
6.3. clean the bonnet regularly by hand washing with soap and water.
Do not immerse the foam pad in water. Washing the bonnet is sufficient.
6.4. to remove the foam pad, proceed as follows:
6.4.1. remove the bonnet.
6.4.2. Insert a rod (cross headed screwdriver or similar) into the hole in the side of the pad mounting.
6.4.3. rotate the pad until the rod contacts the counter-weight.
6.4.4. undo the centre bolt using a 14mm socket. the centre bolt has a reversed thread, turn it clockwise to undo it and anti-clockwise to
tighten it.
environmental Protection.
recycle unwanted materials instead of disposing of
them as waste. All tools, accessories and packaging
should be sorted, taken to a recycle centre and
disposed of in a manner which is compatible with
the environment.
When the product is no longer required, it must be
disposed of in an environmentally protective way.
rechargeable battery contains nickel cadmium
(nicad). It is recyclable. take to your local recycling
centre to be disposed of properly. Do not incinerate
nicad battery as it may explode when exposed to
fire. Do not attempt to open battery pack.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPorTANT: no liability is accepted for incorrect use of this product.
WArrANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INForMATIoN: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
sole UK distributor, sealey Group,
Kempson Way, suffolk Business Park ,
Bury st. Edmunds, suffolk,
IP32 7Ar
www.sealey.co.uk
Web
email
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within
these regulations), that they are registered with Valpak’s registered compliance scheme. Jack sealey Ltd’s Batteries Producer registration number (BPrn) is BPrn00705
risk of Hand Arm Vibration Injury
cordless Polisher 18V, Model no. cP2518.V2 when operated in accordance with these instructions and tested in accordance with
Bs En 28662-1:1993, Iso 8662-1:1988 and Bs En Iso 8662-8:1997 results in the following vibration emission declared in accordance with
Bs En 12096:1996.
Measured vibration emission value: 6.73m/s²
Uncertainty: 2.69m/s²
these values are suitable for comparison with emission levels of other tools that have been subject to the same test.
This tool may cause hand-arm vibration syndrome if its use is inadequately managed.
this is a ‘ No loAd’ vibration figure.
A competent person should carry out a risk assessment following HsE guidelines.
Measurement results can be highly variable, depending on many factors, including the operator's technique, the condition of the work
equipment, the material being processed and the measurement method.
recommended Measures to reduce risk of hand-arm vibration syndrome:
We recommend appropriate safety equipment is utilised and regular breaks for the operator are employed to reduce any residual risk of
fatigue or repetitive strain injury.
Original Language Version cP2518.V2 Issue: 3 - 22/12/11