Sealey SMT180 - Manual (Page 2)

 Avoid unintentional starting. Keep the tool clean for best and safest performance.

When not in use switch tool off and unplug it from the mains supply. Store it in the case and put in a dry, childproof area.

DO NOT over-reach. Ensure the floor is not slippery and wear non-slip shoes.

DO NOT use the tool for a task it is not designed to perform.

DO NOT operate tool where there are flammable liquids or gases.

DO NOT get the tool wet or use in damp or wet locations.

DO NOT carry the tool by the cable.

DO NOT hold unsecured work in your hand.

DO NOT leave the tool running unattended.

DO NOT operate the tool if any parts are missing or damaged as this may cause failure and/or personal injury.

DO NOT operate the tool when you are tired or under the influence of alcohol, drugs or intoxicating medication.
2. INTRODUCTION
3. SPECIFICATION
One tool suitable for multiple tasks such as sanding, scraping and cutting various materials. Single speed with 180W motor and sealed bearings.
Includes sanding discs, backing pad, offset cutting blade and offset scraper all supplied in a convenient storage case. Full range of additional
accessories available.
Model No: . . . . . . . . . . . . . . . . . . . . . . SMT180
Motor Power: . . . . . . . . . . . . . . . . . . . . . . 180W
Supply: . . . . . . . . . . . . . . . . . . . . . . . . . . . .230V
No Load Speed: . . . . . . . . . . . . . . . . .23000rpm
Noise Power: . . . . . . . . . . . . . . . . . . . . . 93dBA
Noise Pressure: . . . . . . . . . . . . . . . . . . . 82dBA
Vibration: . . . . . . . . . . . . . . . . . . . . . . .3.78m/s²
Uncertainty: . . . . . . . . . . . . . . . . . . . . .1.89m/s²
Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.2kg
Accessories: . . . . . . . . 1 x Offset Cutting Blade,
1 x Offset Scraper,
4 x Sanding Discs,
1 x Triangle Backing Pad.
Original Language Version
SMT180 Issue:1-04/12/14
© Jack Sealey Limited