Sealey RS125 User Manual

Roadstart unit, Rs125.v2, Instructions for

Advertising
background image

INSTRUCTIONS FOR:

ROADSTART UniT

MODEL No:

RS125.V2

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and

properly maintained, give you years of trouble free performance.

IMPORTANT: BEFORE USinG THiS PRODUCT, PLEASE READ THE inSTRUCTiOnS CAREFULLY. MAKE CAREFUL nOTE OF SAFETY inSTRUCTiOnS, WARninGS

AnD CAUTiOnS. THiS PRODUCT SHOULD OnLY BE USED FOR iTS inTEnDED PURPOSE. FAiLURE TO FOLLOW THESE inSTRUCTiOnS MAY CAUSE DAMAGE

AnD/OR PERSOnAL inJURY AnD WiLL inVALiDATE THE WARRAnTY. RETAin THESE inSTRUCTiOnS FOR FUTURE USE.

IMPORTANT: To reduce the risk of a battery explosion, follow these instructions and those published by the battery manufacturer and the

manufacturer of any equipment you intend to use in the vicinity of the battery. Remember to review warning marks on all products and on

engines.
1.1.

PERSOnAL PRECAUTiOnS

Ensure there is another person within hearing range, or close enough to come to your aid should a problem arise, when working near

a lead-acid battery.

Have fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.

Wear safety eye protection and protective clothing. Avoid touching eyes while working with a battery.

Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with cool, clean

running water for at least 15 minutes and seek immediate medical attention.

Remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit current

high enough to weld a ring or the like to metal, which may cause severe burns.
1.2.

iMPORTAnT SAFETY inSTRUCTiOnS

Familiarise yourself with the applications, limitations and potential hazards of the RoadStart.

Keep the unit in good working order and condition. Replace damaged parts immediately.

Use only recommended parts. To use unapproved parts may be dangerous and will invalidate your warranty.

The RoadStart must only be opened and checked by qualified service personnel.

DO nOT disassemble the unit for any reason.

Keep children and unauthorised persons away from the work area.

Keep work area clean and tidy and free from unrelated materials. Ensure that there is adequate lighting.

If the RoadStart receives a sharp knock or blow, it must be checked by a qualified service agent before being used.

When not in use re-charge every two months.

DO nOT touch positive and negative clamps together as this could cause an explosion.

DO nOT smoke or allow a spark, or flame in the vicinity of the battery or engine.

DO nOT drop any metal item onto the battery as it may spark or short circuit the battery, which could cause an explosion.

DO nOT use RoadStart to recharge dry cell batteries that are commonly used with home appliances. These batteries may explode and

cause personal injury and damage to property.

DO nOT charge or boost a frozen battery.

DO nOT use attachments other than those recommended. To do so may cause damage to the unit and other equipment and possible

personal injury.

DO nOT pull or carry the unit by its cables and do not pull the negative and positive clamps from the battery terminals.

DO nOT operate in vicinity of flammable liquids or gases.

DO nOT recharge the unit with plugs, cables or attachments that are damaged. Replace such items immediately.

DO nOT use this RoadStart to perform a task for which it is not designed.

DO nOT store the unit in damp or wet locations or where the temperature may exceed 50°C.

DO nOT submerge the unit in water.

DO nOT use whilst under the influence of drugs, alcohol or intoxicating medication.

DO nOT leave the unit in a totally discharged state for an extended period of time as this may result in permanent damage to the battery.

DO nOT cross-connect the power leads from the RoadStart to the battery. Ensure that positive is to positive and negative is to negative.

Ensure that the unit is fully charged before storage.

1. SAFETY inSTRUCTiOnS

WARninG! RiSK OF EXPLOSiVE GASES. Working in the vicinity of a lead acid battery is dangerous because it can

generate explosive gases. It is important to remember that batteries generate explosive gases during normal operation.

WARninG! This equipment contains a sealed, non-spillable lead acid battery. This must be disposed of in accordance with

local regulations.

iMPORTAnT WARRAnTY inFORMATiOn: KEEP YOUR ROADSTART HEALTHY

Read and understand the general safety and operating instructions before use. The following information is intended to help you

keep the product in top working order.

nOTE – The battery in this unit is a consumable item and its ability to accept charge will reduce over time. We will warrant it

against mechanical and electrical defect for a period of one year - this does not cover fair wear and tear.

If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we will

not replace the battery even if it is less than one year old.

You can help prolong the life cycle of the battery by following a few simple guidelines.

Plug in your new RoadStart to the mains transformer and make an INITIAL charge lasting 72 hours.

Ensure the unit is fully charged before storage.

DO nOT leave the RoadStart for longer than 2 months without putting it on charge.

DO nOT attempt to start a vehicle when the RoadStart battery voltage is reduced to less than 7V.

DO nOT drop or handle the RoadStart roughly – this will break or disconnect the battery terminals rendering the battery useless and the

warranty void.

DO nOT use any other charger, other than the one supplied, to recharge the battery.

Original Language Version

RS125 V2 Issue: 1 - 11/12/12

© Jack Sealey Ltd

Advertising