Sealey RB951 User Manual
Rotating beacons 12/24volt, Instructions for, Various fittings
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND
CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY
CAUSE DAMAGE OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1.1
GENERAL SAFETY
Familiarise yourself with this product's application and limitations, as well as any specific potential hazards peculiar to the beacon.
Replace or repair damaged parts. Use recommended parts only. Non authorised parts may be dangerous and will invalidate the warranty.
DO NOT use the beacon for any purpose other than for which it is designed.
DO NOT allow children to operate the beacon.
DO NOT operate the beacon if any parts are missing or damaged as this may cause failure or possible personal injury.
When not in use switch the beacon off and where appropriate remove plug from power supply.
2. TECHNICAL SPECIFICATIONS
Voltage:...................................................................................12V-24V dc
Type of Bulb:.................................................H1 12V 55W - H1 24V 55W
Index of protection (EN 60598-1):.....................................................IP56
Operating Temperature:....................................................-30°C to +50°C
Radio Interference Filter:.......................... ......... EC95/54 EMC approved
Rotational Speed:...........................................................160 rpm nominal
Approvals:......................................................................................ECE65
3 . INTRODUCTION AND FIxING
Model No’s: RB951, RB952, RB953, RB954, RB955.
Instructions for:
ROTATING BEACONS
12/24Volt
various fittings
●
Sealey rotating beacons are designed to meet the strictest European standards.
●
European, British, and local laws must be observed when using the beacon.
●
Heavy-duty ABS base.
●
Quick release UV stable dome will not fade in prolonged sunlight.
●
Supplied with 12V and 24V bulbs.
●
Reverse polarity protected.
RB951
ø128mm
Overall height: 200mm
Length of mounting: 40mm
RB952
ø170mm
Height: 140mm
RB953
ø165mm
Height: 235mm
RB955
ø165mm
Height: 235mm
3.1 RB951:
12mm Single Bolt Fixing
Fixing Instructions
:
3.1.1 Drill a 13mm mounting hole in a suitable point on the vehicle.
3.1.2 Connect to cables of at least 2mm² section and use an 8Amp fuse; check polarities.
3.1.3 Fix the beacon by using nuts and washers according to the type and shape of the mounting
surface.
RB951,RB952,RB953,RB954,RB955 Issue: 1 -10/10/12
© Jack Sealey Ltd
Original Language Version
ø128mm
Height: 170mm
RB954