Fig.1, Environmental protection, Weee regulations – Sealey IWMH2013 User Manual

Page 2: Mounting, Introduction 3. specification, Operation 6. maintenance

Advertising
background image

4. MOUNTING

4.1. WALL MOUNTING (fig.1).

IMPORTANT! The heater should always have a minimum clearance of 500mm from a ceiling and at least 500mm from any

perpendicular wall and 1m from any object. Ensure that mounting surface is capable of supporting the weight of the heater.

4.1.1. Drill four holes using the above diagram to refer to their spacings. Insert four screws into the holes and hook the heater over and gently

allow the heater to drop down into their mounting plate slots.

4.2. INSTALLATION

IMPORTANT! This heater is supplied without a plug. This heater can be fitted with a plug or if it is to be installed into a bathroom

or similar location it should be wired into a fused isolator switch. Both these jobs must be completed by a qualified

electrician.

2. INTRODUCTION

3. SPECIFICATION

A totally dry heat, no condensation, no gas, no fumes and no smell.

Reaches maximum heat output within seconds of being turned on. Highly

polished aluminium reflector for maximum heat efficiency. Adjusts

horizontally through 45° while mounted. Three settings controlled by pull

chain, allow unit to be on full, half or low power. Indicator panel allows easy

indentification of settings. Ideal for industrial or domestic applications.

Suitable for indoor use only.

5. OPERATION

6. MAINTENANCE

WARNING! Ensure you read, understand and apply the safety instructions in Section 1 before using the heater.

5.1. Ensure the heater is at least 1m from any object. The heater can be tilted from 0° to 45°, set it to the required angle before switching the

heater on.

5.2. Pull cord to turn on, once, twice or three times to select desired heat setting and a fourth time time to turn off.

fig.1

NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.

IMPORTANT: No liability is accepted for incorrect use of this product.

WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.

01284 757500

01284 703534

[email protected]

Sole UK Distributor, Sealey Group,

Kempson Way, Suffolk Business Park

,

Bury St. Edmunds, Suffolk,

IP32 7AR

www.sealey.co.uk

W e b

email

Original Language Version

Model No: . . . . . . . . . . . . . . . . . . . . .IWMH2013

Power: . . . . . . . . . . . . . . . . . . . . . . .1500W

Supply: . . . . . . . . . . . . . . . . . . . . . . .230V - 13A

Dimensions: . . . . . . . . . . . . . . . . . . .455x100x180mm

Mounting Bracket Stand Off . . . . . . .59mm

Minimum Mounting Height . . . . . . . .1800mm

Environmental Protection.

Recycle unwanted materials instead of disposing of them as

waste. All tools, accessories and packaging should be sorted,

taken to a recycle centre and disposed of in a manner which

is compatible with the environment.

WEEE Regulations.

Dispose of this product at the end of its working life in compliance

with the EU Directive on Waste Electrical and Electronic Equipment.

When the product is no longer required, it must be disposed of in an

environmentally protective way. Contact your local solid waste

authority for recycling information.

© Jack Sealey Limited

117mm

41mm

6.1. Make sure the heater plug is disconnected or the heater is isolated from the mains supply before any cleaning is attempted. Also allow the

heater to cool completely.

DO NOT use water or other liquids, or harsh abrasive cleaners to clean the heater. DO NOT touch the carbon

fibre elements with fingers as this may damage the tube.

6.2. Clean the exterior with a soft damp cloth with some mild detergent.

6.3. To replace any of the elements or lamps, contact your authorised Sealey dealer.

NOTE: Children of less than 3 years should be kept away unless supervised continuously.

Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended

normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the

hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.

CAUTION: Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and

vulnerable people are present.

NOTE: This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or

lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand

the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

IWMH2013 Issue: 2(L) - 11/05/15

Advertising