Sealey IWMH3000 User Manual

Infrared heaters, Instructions for, Model no's

Advertising
background image

1.1.

ELECTRICAL SAFETY

WARNING! It is the responsibility of the owner and the operator to read, understand and comply with the following: You must check all

electrical products, before use, to ensure that they are safe. You must inspect power cables, plugs, sockets and any other connectors for

wear or damage. You must ensure that the risk of electric shock is minimised by the installation of appropriate safety devices. A Residual

CurrentCircuit Breaker (RCCB) should be incorporated in the main distribution board. We also recommend that a Residual Current Device

(RCD) is used. It is particularly important to use an RCD with portable products that are plugged into a supply which is not protected by an

RCCB. If in any doubt consult a qualified electrician. You may obtain a Residual Current Device by contacting your Sealey dealer.

You must also read and understand the following instructions concerning electrical safety.

1.1.1. The Electricity at Work Act 1989 requires that all portable electrical appliances, if used on business premises, are tested by a qualified

electrician, using a Portable Appliance Tester (PAT), at least once a year.

1.1.2. The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of those appliances and

the safety of the appliance operators. If in any doubt about electrical safety, contact a qualified electrician.

1.1.3. Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply. See 1.1.1 and 1.1.2 and use

a Portable Appliance Tester.

1.1 .4. Ensure that cables are always protected against short circuit and overload.

1.1.5. Regularly inspect power supply cables and plugs for wear or damage and check all connections

to ensure that none are loose.

1.1.6. Important: Ensure that the voltage marked on the appliance matches the power supply to be

used and that the plug is fitted with the correct fuse - see fuse rating at right.

1.1.7.

DO NOT pull or carry the appliance by the power cable.

1.1.8.

DO NOT pull the plug from the socket by the cable.

1.1.9.

DO NOT use worn or damaged cables, plugs or connectors. Immediately have any faulty item

repaired or replaced by a qualified electrician. When a BS 1363/A UK 3 pin plug is damaged, cut

the cable just above the plug and dispose of the plug safely.

Fit a new plug according to the following instructions (UK only).

a) Connect the GREEN/YELLOW earth wire to the earth terminal ‘E’.

b) Connect the BROWN live wire to the live terminal ‘L’.

c) Connect the BLUE neutral wire to the neutral terminal ‘N’.

d) After wiring, check that there are no bare wires, that all wires have been correctly connected,

that the cable outer insulation extends beyond the cable restraint and that the restraint is tight. Double insulated products, which are

always marked with this symbol , are fitted with live (brown) and neutral (blue) wires only. To rewire, connect the wires as indicated

above -

DO NOT connect either wire to the earth terminal.

1.1.10. Products which require more than 13 amps are supplied without a plug. In this case you must contact a qualified electrician to ensure

that a suitably rated supply is available. We recommend that you discuss the installation of an industrial round pin plug and socket

with your electrician.

1.1.11. If an extension reel is used it should be fully unwound before connection. A reel with an RCD fitted is preferred since any appliance

plugged into it will be protected. The cable core section is important and should be at least 1.5mm², but to be absolutely sure that the

capacity of the reel is suitable for this product and for others which may be used in the other output sockets, we recommend the use

of 2.5mm² section cable.

1.2.

GENERAL SAFETY INSTRUCTIONS

Familiarise yourself with the application and limitations of the heater.

Ensure the heater is in good order and condition before use. If in any doubt do not use the unit and contact an electrician.

Only use recommended attachments and parts. To use unapproved items may be dangerous and will invalidate your warranty.

Check that element guards are in place, undamaged and firmly attached.

DO NOT get the heater wet or use in damp or wet locations or areas where there is condensation.

Keep tools and other items away from the heater when it is in use.

Keep the work area clean and clear of unnecessary items.

Keep children and unauthorised persons away from the heater, as it gets

very hot.

Disconnect from mains before moving or attempting any cleaning or maintenance.

DO NOT locate the heater below the power outlet.

DO NOT move the heater whilst in operation or even when still warm.

DO NOT touch the heater elements, even when cold.

DO NOT dis-assemble the heater for any reason. The heater must be checked by qualified personnel only.

DO NOT use the heater for a task for which it is not designed .

WARNING! If a fuse blows, ensure it is replaced with an identical fuse type and rating.

When not in use, store the heater carefully in a safe, dry, child proof location.

WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that

may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into

this product, but must be applied by the operator.

RECOMMENDED FUSE RATING

13 AMP

(Models IWMH1500 & IWMH3000 only,

see 1.1.10 for Model IWMH4500)

INSTRUCTIONS FOR:

INFRARED HEATERS

MODEL NO'S:

IWMH1500, IWMH3000, IWMH4500

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE

PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR

PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these

instructions, and properly maintained, give you years of trouble free performance.

1. SAFETY

Original Language Version

© Jack Sealey Limited

IWMH1500, IWMH3000, IWMH4500 ISSUE : 5(L) 23/07/14

Advertising
This manual is related to the following products: