Sealey SCF8W User Manual

Scf8w, Instructions for, Model no

Advertising
background image

instructions for:

CLIP-ON faN 2 SPEED 8” 230V

model no:

SCf8W

thank you for purchasing a sealey product. manufactured to a high standard this product will, if used according to these instructions and

properly maintained, give you years of trouble free performance.

I

MPORTANT: PLEaSE REaD THESE INSTRUCTIONS CaREfULLY. NOTE THE SafE OPERaTIONaL REQUIREMENTS, WaRNINGS aND

CaUTIONS. USE THE PRODUCT CORRECTLY aND WITH CaRE fOR THE PURPOSE fOR WHICH IT IS INTENDED. faILURE TO DO SO

MaY CaUSE DaMaGE OR PERSONaL INJURY, aND WILL INVaLIDaTE THE WaRRaNTY.

PLEaSE KEEP INSTRUCTIONS SafE fOR fUTURE USE.

1. SafETY INSTRUCTIONS

1.1.

ELECTRICaL SafETY

WaRNING! it is the responsibility of the owner and the operator to read, understand and comply with the following:

You must check all electrical products, before use, to ensure that they are safe. You must inspect power cables, plugs, sockets and

any other connectors for wear or damage. You must ensure that the risk of electric shock is minimised by the installation of

appropriate safety devices. A residual current circuit Breaker (rccB) should be incorporated in the main distribution board. We also

recommend that a residual current device (rcd) is used. it is particularly important to use an rcd with portable products that are

plugged into a supply which is not protected by an rccB. if in any doubt consult a qualified electrician. You may obtain a residual

current device by contacting your sealey dealer.

You must also read and understand the following instructions concerning electrical safety.

1.1.1. the electricity at Work Act 1989 requires that all portable electrical appliances, if used on business premises, are tested by a qualified

electrician, using a Portable Appliance tester (PAt), at least once a year.

1.1.2. the Health & safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of those appliances

and the safety of the appliance operators. if in any doubt about electrical safety, contact a qualified electrician.

1.1.3. ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply. see 1.1.1 and 1.1.2

and use a Portable Appliance tester.

1.1.4. ensure that cables are always protected against short circuit and overload.

1.1.5. regularly inspect power supply cables and plugs for wear or damage and check all

connections to ensure that none is loose.

1.1.6. important: ensure that the voltage marked on the appliance matches the power supply

to be used and that the plug is fitted with the correct fuse - see fuse rating at right.

1.1.7.

DO NOT pull or carry the appliance by the power cable.

1.1.8.

DO NOT pull the plug from the socket by the cable.

1.1.9.

DO NOT use worn or damaged cables, plugs or connectors. immediately have any faulty

item repaired or replaced by a qualified electrician. When a Bs 1363/A uK 3 pin plug is

damaged, cut the cable just above the plug and dispose of the plug safely.

fit a new plug according to the following instructions (uK only).

a) Connect the GREEN/YELLOW earth wire to the earth terminal ‘E’.

b) Connect the BROWN live wire to the live terminal ‘L’.

c) Connect the BLUE neutral wire to the neutral terminal ‘N’.

d) After wiring, check that there are no bare wires, that all wires have been correctly connected, that the cable outer insulation extends

beyond the cable restraint and that the restraint is tight. double insulated products, which are always marked with this symbol , are

fitted with live (brown) and neutral (blue) wires only. to rewire, connect the wires as indicated above -

DO NOT connect either wire to

the earth terminal.

1.1.10. Products which require more than 13 amps are supplied without a plug. in this case you must contact a qualified electrician to ensure

that a suitably rated supply is available. We recommend that you discuss the installation of an industrial round pin plug and socket

with your electrician.

1.1.11. if an extension reel is used it should be fully unwound before connection. A reel with an rcd fitted is preferred since any appliance

plugged into it will be protected. the cable core section is important and should be at least 1.5mm², but to be absolutely sure that the

capacity of the reel is suitable for this product and for others which may be used in the other output sockets, we recommend the use

of 2.5mm² section cable.

1.2.

GENERaL SafETY

disconnect the fan from the mains power when not in use, and before servicing or performing any maintenance.

use the fan in dry areas only. do not use in wet or high condensation locations such as bathrooms, showers, or pools.

WaRNING! if fan falls into water, immediately disconnect from the mains power supply. Do not touch the fan until the mains

power supply has been disconnected.

Always disconnect the fan from the power supply when moving it from one location to another.

Keep the fan clean and maintained in good condition (use an authorised service agent).

use recommended parts only (unauthorised parts may be dangerous, and will invalidate your warranty).

DO NOT insert any objects through the fan guard.

DO NOT cover the fan.

DO NOT immerse the fan in water or any other liquid.

DO NOT allow children to operate the fan.

DO NOT place the fan where it may be knocked over easily, or where the lead may cause a person to trip.

DO NOT use the fan outdoors.

DO NOT use an extension cord unless it has been approved by an electrical authority.

When not in use store in a safe, dry, childproof location.

RECOMMENDED

fUSE RaTING 3 aMP

Blue

Neutral

Wire

Yellow & Green

Earth Wire

Cable

Restraint

Brown

Live

Wire

Original Language Version

scf8W issue: 1 - 11/11/11

usE BY PERsONs WITh REduCEd PhYsICAL, sENsORY OR MENTAL CAPABILITIEs.

this appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of

experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person

responsible for their safety. children should be supervised to ensure that they do not play with the appliance.

Advertising