Sealey LC300ST User Manual

Heavy duty log stand ø230mm capacity, Lc300st, Fig.1

Advertising
background image

1. SAFETY INSTRUCTIONS

2. INTRODUCTION & SpECIFICATION

Maintain the log stand in good condition. Replace or repair damaged parts.

Keep the log stand clean.

Locate the log stand in a suitable working area. Keep area clean and tidy and ensure there is adequate lighting.

Ensure the log is correctly held and balanced before commencing work.

Maintain correct balance and footing. Ensure the floor/ground is not slippery and wear non-slip shoes and appropriate protective clothing

for the tool you are using.

DO NOT use the log stand for any purpose other than that for which it is designed.

DO NOT operate the log stand if any parts are missing as this may cause failure and/or personal injury.

DO NOT use the log stand if you are tired or under the influence of drugs, alcohol or medication.

3. ASSEMBLY

Easy to assemble and safe to use. Folds down flat for easy storage and transportation. Holds logs up to Ø230mm and any reasonable length.

Compatable with chain saw use for ease and safety.

instRuCtions FoR:

HEAVY DUTY LOG STAND Ø230MM CApACITY

ModEL no:

LC300ST

thank you for purchasing a sealey product. Manufactured to a high standard this product will, if used according to these instructions and

properly maintained, give you years of trouble free performance.

IMPORTANT: pLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OpERATIONAL REQUIREMENTS, WARNINGS, AND

CAUTIONS. USE THIS pRODUCT CORRECTLY, AND WITH CARE FOR THE pURpOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO

MAY CAUSE DAMAGE AND/OR pERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.

WARNING! the warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that may occur. it must

be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be applied by the

operator.

NOTE: this appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of

experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible

for their safety. Children should be supervised to ensure that they do not play with the appliance.

Model No: . . . . . . . . . . . . . . . . LC300ST

Overall Size Open (WxDxH): . 440x480x930mm

Overall Size Folded: . . . . . . . . 440x90x690mm

Maximum Log Diameter: . . . . 230mm

Weight: . . . . . . . . . . . . . . . . . . 8.14kg

3.1.

unpack the product and lay it down as shown in Figure 1. Ensure the clamp is done up to prevent the top bar moving at this point.

WARNING!

take care to avoid the sharp spikes when assembling the stand wear suitable gloves.

3.1.1. Lift the rear support up, use the bolts and wing nuts to secure the support bar on each side.

3.1.2. Lift the stand up and move its legs apart to enable it to stand securely.

3.1.3. To dismantle the stand for storage lower and clamp the top bar, lay it down and remove support bar bolts to allow it to lay flat.

LC300st issue no:1 - 28/10/13

© Jack sealey Limited

Original Language Version

fig.1

Advertising