Sealey AK4567D - Manual

❐ WARNING! Ensure health & safety, local authority, and general workshop practice regulations are strictly adhered to when using this
equipment.
✓
Familiarise yourself with product application and limitations, as well as the specific potential hazards peculiar to this product.
✓ Maintain the hose reel in good condition (use an authorised service agent).
✓
Replace or repair damaged parts. Use genuine parts only. Non authorised parts will invalidate the warranty.
✓
Use only lubricants up to SAE 150 viscosity and antifreeze liquids.
✓
Ensure safety eye protection and protective clothing are worn when using this product.
✓
Keep the work area clean, uncluttered and ensure there is adequate lighting.
✓ Maintain correct balance and footing. Ensure the floor is not slippery and wear non slip shoes.
✓
Keep children and unauthorised persons away from the working area.
✓
After use, drain any fluids from the equipment before storage.
✓ Dispose of waste liquids in accordance with local authority regulations.
✓
Disconnect air pressure from equipment when not in use.
✗
DO NOT exceed the maximum working pressure of 2000psi.
✗
DO NOT leave the hose on the ground, retract when not in use.
✗
DO NOT point attachments at people or animals.
✗ DO NOT use the equipment near open flames.
✗
DO NOT smoke whilst using this equipment.
✗
DO NOT use with corrosive fluids.
✗
DO NOT dismantle, tamper with or adapt the reel for any purpose other than for which it is designed.
✗
DO NOT use the unit if it has been dropped or mishandled, check the unit to ensure there is no damage.
✓ Keep the equipment clean and store in a safe dry, childproof location.
❐ WARNING! DO NOT allow uncontrolled discharge of fluids thus polluting the environment. All liquids must be disposed of according to
local authority regulations.
InStRUctIonS FoR:
OIl hOse Reel
ReTRAcTAble 10mTR
Model no:
AK4567D
1. sAFeTY INsTRUcTIONs
2. INTRODUcTION
3. AssemblY
4. OpeRATION
IMPORTANT: pleAse ReAD These INsTRUcTIONs cAReFUllY. NOTe The sAFe OpeRATIONAl ReQUIRemeNTs,
WARNINGs AND cAUTIONs. Use ThIs pRODUcT cORRecTlY AND WITh cARe FOR The pURpOse FOR WhIch IT Is
INTeNDeD. FAIlURe TO DO sO mAY cAUse DAmAGe OR peRsONAl INJURY AND WIll INVAlIDATe The WARRANTY.
pleAse ReTAIN These INsTRUcTIONs FOR FUTURe Use.
thank you for purchasing a Sealey product. Manufactured to a high standard this product will give you years of trouble free performance
if these instructions are carefully followed and the product is correctly maintained.
AK4567D Issue no: 1 - 19/11/08
For use with AK4560D pump station. Heavy-duty steel and powder coating finish for corrosion resistance. Four roller fairlead allows smooth
running of hose whatever the angle of hose or mounting position of reel. Multi position ratchet lock with fully enclosed spring. Includes 1.5mtr
connection hose for connecting reel to pump.
3.1 Mount the reel to a wall or bench using appropriate fixings (not supplied).
3.2 connect the 1.5mtr hose from the centre reel connection to the
AK4560D pump station.
3.3 connect a dispensing gun/meter to the outlet connection.
Model: AK4567D
Hose Length: 10mtr
Maximum Pressure: 2000psi
Hose Inlet/outlet: 1/2"BSP
Hose Size (ID): 1/2"
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
ImpORTANT: no liability is accepted for incorrect use of product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORmATION: call us for a copy of our latest catalogue on 01284 757525 and leave your full name and address including your postcode.
01284 757500
[email protected]
www.sealey.co.uk
01284 703534
sole U.K. Distributor
sealey Group
Bury St. Edmunds
Suffolk.
Web
4.1 Pull the hose at a steady pace, a clicking noise from the ratchet will be
heard, when the hose is at the desired length, gently release the
pressure and the hose will lock into position.
4.2 to retract the hose, pull the hose out a short distance and release the
hose will now rewind.
❐ WARNING! DO NOT let go of the hose, guide it back until it is fully
retracted. Failure to do this may damage the gun or metering device
on the end of the hose.