Operation, Maintenance – Sealey DH03 User Manual
Page 2
fig.2
fig.3
fig.4
5. oPErAtion
5.1
Lifting A drum
5.1.1. Close the valve (fig.4) fully clockwise. Foot pump to elevate the fulcrum assembly lower jaw marginally below the drum rim external lip
(fig.1).
5.1.2. Move the drum loader to bring the support frame yoke into contact with the drum (fig.1). Engage the top jaw with the drum rim inside
diameter; this may require lowering the jaws slightly to obtain the fullest register.
Warning! Ensure that the drum is as low as possible for transporting, elevating only if required at the destination. Ensure there
are no obstacles enroute and the surface is suitable to take the weight of the fully laden drum.
5.1.3. Ensure that the drum rim is engaged with the fulcrum assembly jaws (fig.1). With both hands on the handle bars, foot pump to raise the
drum clear of the ground.
5.1.4. Use the handle bars (fig.4) to push, pull and steer the drum loader.
5.2.
Lowering A drum
5.2.1. To lower the drum slowly, turn the release valve anticlockwise in a controlled manner until the drum is standing firmly on the ground.
5.2.2. Release the fulcrum assembly jaws by lifting the top jaw from the drum rim manually and pull the drum loader away from the drum.
6. MAintEnAncE
6.1.
Regularly check the drum loader chassis for rigidity including the integrity of the castors.
6.2.
Regularly check the fulcrum assembly for wear. Replace worn jaws which may cause poor rim grip.
6.3.
Regularly check the linkages and pins for wear or missing retaining split pins which could cause lifting failure.
6.4.
Keep the column guides lubricated with grease as supplied.
do not contaminate the steering handles with grease.
Viewed On
Arrow 'A'
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
iMPortAnt: No liability is accepted for incorrect use of product.
WArrAntY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
IMPORTANT: NO RESPONSIBILITY IS ACCEPTED FOR INCORRECT USE OF THE DRUM LOADER.
Hydraulic products are only repaired by local service agents. We have service/repair agents in all parts of the UK.
DO NOT RETURN PRODUCT TO US. Please telephone us on 01284 757500 to obtain the address and phone number of your local agent.
If the product is under guarantee please contact your dealer.
DH03.V2 Issue No: 2(I) - 05/06/15
Original Language Version
© Jack Sealey Limited
01284 757500
01284 703534
Sole uK distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Transporter Base Frame
(inverted)
M12
M8
M8
Transporter
Base Frame
Handlebars
Column c/w
Hydraulics,
Fulcrum & Drum
Support Frame
Socket
Set
Screw
(43)
Socket Head
Cap Screw &
Washer
(70) (62)
'A'
Fulcrum Jaws
Environmental Protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
fig.5