Sealey PT2200 - Manual (Page 3)

THE PROBLEM THE CAUSE THE SOLUTION
The forks do not reach maximum
height.
Hydraulic oil level too low.
Too cold.
Top up the oil.
Operate at rated temperature.
The forks do not raise. No hydraulic oil Fill with hydraulic oil
The oil is contaminated. Change the oil.
Air in the hydraulic system. Purge the air as described in Section 6.
The forks will not descend Truck stored in raised position allowing
exposed piston rod to corrode and jam.
Lubricate rod regularly and store truck
in lowered position.
Piston rod or pump body deformed as a result
of overloading or unbalanced load.
Replace piston rod or pump body.
Leaks. Seals worn, damaged or cracked. Replace seals.
The forks descend and cannot be
maintained in the raised position.
Release valve not fully closed owing to
impurities in oil.
Change the oil.
Air in the hydraulic system. Purge the air as described in Section 6.
Seals worn, damaged or cracked. Replace seals.
Parts of hydraulic system cracked or worn. Inspect and replace.
7. TROUBLE SHOOTING
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling
centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires
disposal, drain off any fluids (if applicable) into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without
prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
01284 757500
01284 703534
[email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Original Language Version © Jack Sealey Limited PT2200 Issue No.1 - 20/11/14
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or telephone 01284 757500.