Sealey TA126 User Manual
Current tester 30a, Ta126, Fig.1
INSTRUCTIONS FOR:
CURRENT TESTER 30A
MODEL NO:
TA126
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly
maintained, give you years of trouble free performance.
IMPORTANT PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS,
AND CAUTIONS. USE THIS PRODUCT CORRECTLY, AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO
DO SO MAY CAUSE DAMAGE, OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY.
p
WARNING! Suitable only for automotive circuits up to 48V DC.
Not suitable for domestic 110 - 230V applications.
Observe standard workshop safety procedures when using the tester.
p
WARNING! The Fuse blade may become hot during testing. Allow to cool before removing.
p
WARNING! DO NOT exceed Maximum Load: 30A/48V for Max 10sec.
Ensure vehicle ignition is switched
OFF before connecting or disconnecting TA126.
Keep the work area clean, uncluttered and ensure there is adequate lighting. Keep tools and other
items away from the engine, and ensure you can see the battery and working parts of engine clearly.
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery. Contain or tie back
long hair.
Keep children and unauthorised persons away from the working area.
DO NOT disassemble. TA126 must be checked by qualified service personnel only.
DO NOT get the tester wet or use in damp or wet locations or areas where there is condensation.
DO NOT use the tester for any purpose other than for which it is designed.
DO NOT pull by the cables to free from the fuse terminals.
DO NOT operate TA126 if damaged.
When not in use store in a safe, dry, childproof location.
p
WARNING! The warnings, cautions and instructions referred to in this manual cannot cover all
possible conditions and situations that may occur. It must be understood that common sense and
caution are factors which cannot be built into this product, but must be applied by the operator.
1. SAFETY INSTRUCTIONS
2. INTRODUCTION / SPECIFICATION
Fast, accurate and safe current measurement at the
fuse box or battery. Ideal for fault-finding on car and
commercial vehicle electrical circuits. Features large
LCD display with numeric and bar-type functions.
Plugs directly into the vehicle’s fuse board. Supplied
with mini, standard adaptors and fused crocodile
clips. Compatible with alternative probes using the
standard Ø4mm banana adaptors.
Range: ....................... 0-30A - 0-48V
Accuracy: ................... ± 2%
Fuse Type: ................. Mini, Standard
Max Load: .................. 30A/48V for Max 10sec
Operating Temp: ........ 0°C to 50°C (32°F to 122°F)
Storage Temp: ........... -20°C to 60°C (-4°F to 140°F)
Relative Humidity: ...... <70% operating, <80% storage
Operating Altitude: ..... 7000ft (2000m) maximum
1. LCD Display
2. ZERO Button
3. HOLD Button
fig.1
4. Power On/Off Button
5. DATA Link
6. Clip Connector
7. Standard Blade Connector
8. MINI Blade Connector
9. Fuse Jack
Original Language Version
TP126 Issue: 1 - 06/06/11