Sealey VS0207 - Manual

1. safety instructions
instructions for:
brake & cLutcH Pressure
bLeeDer kit 12 voLt
model no:
vs0207
thank you for purchasing a sealey product. manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT: PLease reaD tHese instructions carefuLLy. note tHe safe oPerationaL reQuireMents,
WarninGs anD cautions. use tHis ProDuct correctLy, anD WitH care for tHe PurPose for WHicH it is
intenDeD. faiLure to Do so May cause DaMaGe anD/or PersonaL inJury anD WiLL invaLiDate tHe
Warranty.
Original Language Version Vs0207 issue: 1 -14/06/13
1.1. PersonaL Precautions
 Wear safety eye protection and protective clothing. Avoid touching eyes while working near battery.
 Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with cool, clean
running water for at least 15 minutes and seek immediate medical attention.
 remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit
current which is high enough to weld such items to the vehicle and cause severe burns.
 Do not smoke or allow a spark or flame in the vicinity of the battery or engine.
 WarninG! to prevent the risk of sparking, short circuit and possible explosion Do not drop metal tools in the battery area, or allow
them to touch the battery terminals.
 Do not cross-connect unit to battery. ensure positive (red) clamp is to positive terminal and negative (BlAcK) clamp is to negative
terminal.

WarninG! Brake fluid is hazardous, wear approved eye protection and keep skin contact to a minimum. if brake fluid enters eyes,
rinse immediately with plenty of water and seek medical advice. if swallowed seek medical advice immediately.
 WarninG! Brake fluid is flammable - keep away from sources of ignition, including hot surfaces e.g. exhaust manifold.
 WarninG! Brake fluid will damage paintwork and clothing. Any spillages should be flushed with water immediately.
1.2. GeneraL safety.
 WarninG! ensure Health and safety, local authority and general workshop practice regulations are adhered to when using this unit.
s iMPortant: if possible, refer to the vehicle manufacturer’s service instructions to establish the correct procedure.
 maintain this product in good working order and condition, take immediate action to repair or replace damaged parts.
 use approved parts only. unapproved parts may be dangerous and will invalidate the warranty.
 WarninG! only use new brake fluid, used brake fluid or other fluids will contaminate the system and possible brake system failure
may result.
 Do not use to perform a task for which it is not designed.
 Do not allow untrained persons to use the unit.
 Do not use when tired or under the influence of drugs, alcohol or intoxicating medication.
 WarninG! Do not pollute the environment by allowing uncontrolled discharge of fluids.
 Keep children and unauthorised persons away from the work area.
 Keep work area clean and tidy and free from unrelated materials.
 ensure the work area has adequate lighting.
 ensure that a vehicle which has been jacked up and had its wheels removed, is adequately supported with axle stands.
 WarninG! do not use with mineral fluids unless the machine is manufactured specifically for and dedicated to that purpose. mineral
and conventional fluids do not mix. cross contamination, however small, between mineral and dot 3/4/4.1/5 fluids will always result in
brake failure.
 Do not disconnect universal adaptor from brake fluid reservoir until the unit has been de-pressurised.
 dispose of waste brake fluid in accordance with local authority regulations.
 Always read and comply with the warnings on the brake fluid container.
 Wear suitable clothing to avoid snagging. Do not wear jewellery, and tie back long hair. A full range of personal safety equipment is
available from your sealey dealer.
 When not in use, clean unit and store in a safe, dry, childproof location.
2. introDuction & sPecification
Powered by the vehicle's own 12V dc battery. Allows single-handed bleeding of the vehicle's brake or clutch system and is fitted with a long,
high pressure hose. Bleed pressure is closely controlled up to 2.5bar - suitable for most vehicles (even those with ABs). unit is fitted with
auto-shut-off-device to prevent the system running dry and is supplied with a variety of european, Japanese and us vehicle adaptors, bleed
bottle and fluid extractor.
Model no: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Vs0207
Power supply: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12V
maximum Pressure: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2.5bar
Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7.9kg
cable length: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4mtr
Hose length: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5mtr
tank capacity: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2ltr
© Jack sealey limited