Sealey PFT07 - Manual

❐ WARNING! Ensure Health & Safety, local authority and general workshop practice requirements are
adhered to when using this equipment. Familiarise yourself with the application and limitations, as well as
the potential hazards of the kit.
 This kit is suitable for flaring copper, brass, steel or thin walled aluminium pipe.
 Maintain the kit in good condition.
✓ Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will
invalidate the warranty.
✓ Locate the flaring tools in a suitable work area, keep the area clean
and tidy and ensure there is adequate lighting.
❐ WARNING! Always wear approved eye or face protection when
using the flaring tools.
 Keep children and unauthorised persons away from the working area.

DO NOT use the kit for any purpose other than for which it is designed.

DO NOT use the kit if any parts are damaged or missing as this
may cause failure and/or personal injury.
 DO NOT allow untrained persons to use the kit.

DO NOT attempt to flare piping when you are tired, under
the influence of alcohol, drugs or intoxicating medication.
 When not in use clean kit components, replace in case
and store in a safe, dry, childproof area.
Remember! The safe operation of a vehicle, or other equipment,
may well depend on the quality of the flare produced. Discard any
flare which is mis-formed.
❐ WARNING! The warnings, cautions and instructions discussed in this manual cannot cover all
possible conditions and situations that may occur. It must be understood that common sense and
caution are factors which cannot be built into this product, but must be applied by the operator.
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according
to these instructions and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE
OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT
CORRECTLY AND WITH CARE, FOR THE PURPOSE FOR WHICH IT IS INTENDED.
FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. PLEASE KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
2. INTRODUCTION & SPECIFICATIONS
Produces accurate automotive double flares on most common sizes of brake pipe. Cam-action body mounts in
bench vice for ease of use. Includes dies and clamp blocks for forming most popular flares. Optional 3/8” clamp
block available. Supplied in blow moulded carry-case.
Part
Description
Dies: 4.75mm, 3/16”, 1/4”, 5/16” and 3/8”.
Clamp Blocks: 4.75mm, 3/16”, 1/4” and 5/16”
Optional Clamp Block: 3/8” (available from your Sealey dealer, Part No: PFT07.04).
INSTRUCTION MANUAL FOR:
BRAKE PIPE FLARING TOOL
TURRET TYPE
MODEL No:
PFT07.V2
Original Language Version
PFT07.V2 Issue: 1 - 20/07/11