Sealey VS9000 - Manual

NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component
parts without prior notice. IMPORTANT: No liability is accepted for incorrect use of product. WARRANTY: Guarantee is 12 months
from purchase date, proof of which will be required for any claim. INFORMATION: For a copy of our latest catalogue and promo-
tions call us on 01284 757525 and leave your full name and address, including postcode.
iNstructioNs For:
AIRbAg ReMOvAl TOOl seT
MoDEL No
:
vs9000
1. sAFeTY INsTRUCTIONs
thank you for purchasing a sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained,
give you years of trouble free performance.
IMPORTANT: PleAse ReAD THese INsTRUCTIONs CAReFUllY. NOTe THe sAFe OPeRATIONAl ReQUIReMeNTs, WARNINgs &
CAUTIONs. Use THe PRODUCT CORReCTlY AND WITH CARe FOR THe PURPOse FOR WHICH IT Is INTeNDeD. FAIlURe TO DO sO
MAY CAUse DAMAge AND/OR PeRsONAl INJURY AND WIll INvAlIDATe THe WARRANTY. PleAse KeeP INsTRUCTIONs sAFe
FOR FUTURe Use.
2. INsTRUCTIONs
Caution! Airbags and pretensioners contain explosives and can be dangerous if not handled
correctly. Work on airbag systems should be carried out by a trained and competent person.

WARNINg! Ensure Health & Safety, local authority, and general workshop practice regulations
are adhered to.

Explosive devices are subject to national laws which must be followed. these include
requirements on storage and transportation.

observe component manufacturer’s instructions for safety, handling and installation/removal.

store removed explosive devices in a locked area away from other hazardous materials.

DO NOT expose systems to temperatures above 80°c.

WARNINg! use only diagnostic testers to diagnose faults. DO NOT use multimeters or test
lamps etc. on active airbag (srs) systems, as this may cause accidental deployment.
Disconnect all explosive devices before checking wiring with a multimeter.
read, understand and apply the safety instructions.
Caution! Always refer to manufacturer’s instruction before working on airbag (sRs) systems.
Designed for the safe removal of steering wheel airbags. suitable for use on Audi, BMW, Mercedes,
seat, skoda and Volkswagen vehicles.
Ensure ignition is switched oFF and remove key from ignition. ●
Never use a memory saving device. ●
Disconnect the battery leads. ●
Wait at least 30 minutes after disconnecting the battery leads before working on the system. ●
When fitted, lock pretensioners. ●
Never attempt to repair airbag wiring or components. ●
Never use analogue test meters or test lamps on active airbag (srs) systems, as this may ●
cause accidental deployment.
When working on deployed airbags
Always wear gloves and eye protection when working on deployed airbags because chemical
residue can cause skin irritation. skin that comes into contact with a deployed airbag should be
washed with soap and water immediately.
Re-arming
Before re-arming make sure the vehicle is unoccupied.
check correct operation of airbag (srs) warning lamp.
01284 757500
01284 703534 [email protected]
sole UK Distributor
sealey group,
Bury st. Edmunds, suffolk .
www.sealey.co.uk
Web
email
Vs9000 issuE 1 01/06/10