Sealey MPS8 User Manual
Quick lift off-road/trials bike stand, Mps8, Fig.1 fig.2
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
2.1. Introduction.
Powder coated box section (RHS) steel frame, to ensure strength and durability. Ideal for use with off-road/trials bikes to
easily lift the bike when needing to perform maintenance/services or cleaning. Simple, one foot, step and lift mechanism
means the bike can be instantly raised in one motion.
2. INTRODUCTION & SPECIFICATION
DO NOT sit on the motorcycle on the stand.
DO NOT start the motorcycle on the stand.
DO NOT mount the stand on tarmacadam, as the surface may be unstable.
DO NOT use the stand for a purpose it is not designed to perform.
DO NOT operate the stand if it is damaged.
DO NOT use the stand when you are tired or under the influence of alcohol, drugs or intoxicating medication.
DO NOT allow untrained persons to operate the stand.
DO NOT make any modifications to the stand.
DO NOT operate the stand if parts are missing or damaged.
DO NOT exceed the maximum capacity.
Maintain the
stand in a good clean condition for the best and safest performance.
Locate the stand and motorcycle in a suitable area. Keep area clean, tidy and free from unrelated materials and ensure that there is
adequate lighting. Also ensure that the floor/ground is level and strong enough (preferably concrete) to take the weight of the stand
and the motorcycle.
Maintain correct balance and footing whilst positioning the motorcycle on the stand, do not over reach.
Ensure that the floor is not slippery, wear non-slip footwear. Also essential for safe operation of the foot pedal.
Keep children and unauthorised persons away from the work area.
Before removing a motorcycle from the stand, ensure that there are no obstructions or persons around the motorcycle.
Always support motorcycle to prevent falling.
If using as a front stand, always use in conjunction with another suitable rear stand to ensure full stability.
When not in use, store in a safe, dry, childproof location.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
2.2. Specification.
Model No: .......................................................................MPS8
Minimum Height: ............................................................300mm
Maximum Height: ...........................................................410mm
Maximum Capacity: .........................................................250kg
Original Language Version
MPS8 Issue: 1 - 08/02/13
3. ASSEMbLY INSTRUCTIONS
© Jack Sealey Limited 2013
INSTRUCTIONS FOR:
QUICK LIFT OFF-ROAD/TRIALS bIKE
STAND
MODEL No:
MPS8
Over centre lock
axis centre lines.
Damper
PVC Saddle
Foot pedal
fig.1
fig.2
A
b
The stand is supplied partially assembled with only item A (foot pedal) and B (pair of toggle links) to fit. The contents also include 3
hexagon screws and 3 hexagon stiff nuts.
3.1
Fit the foot pedal [
A] with the supplied screw and stiff nut between "U" bracket.
3.2
Tighten stiff nut until nut and head of screw contact the frame "U" bracket without deforming the bracket.
3.3
Fit the toggle links [
b] as a pair with the supplied screws and stiff nuts to both foot pedal and stand upright square peg.
3.4
Tighten stiff nuts until a similar clearance is obtained as with the "U" bracket and foot pedal (ie the toggle link outer faces will be flush
with the "U" bracket outer faces). Links to be parallel.
Toggle links
"U" bracket