Sealey AFPS1 User Manual
Afps1, Fig.1, Aluminium front paddock stand
InstructIons for:
ALUMINIUM FRONT PADDOCK STAND
MoDEL no:
AFPS1
thank you for purchasing a sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
2.1.
Introduction.
Manufactured from lightweight, durable aluminium. features width adjustment from 200 to 300mm, making it suitable for a wide variety
of sports bikes. fitted with self aligning rubber supports. Design ensures rim and tyre protection at all times. once the bike is
supported, allows easy removal and cleaning of front wheel.
NOTE: All front paddock stands need to be used in conjunction with a suitable rear stand to ensure full stability.
2. INTRODUCTION & SPECIFICATION
WARNING! Before use, ensure that there is nothing attached to the front forks or the fairing of the motorcycle, that will foul
the stand.
Maintain the
stand in a good clean condition for the best and safest performance.
Locate the stand and motorcycle in a suitable area. Keep area clean and tidy and free from unrelated materials and ensure that
there is adequate lighting. Also ensure that the floor/ground is level and strong enough (preferably concrete) to take the weight
of the stand and the motorcycle.
DO NOT mount the stand on tarmacadam, as the surface may be unstable.
Maintain correct balance and footing whilst positioning the motorcycle on the stand, do not over reach and wear non-slip footwear.
Ensure that the floor is not slippery.
Keep children and unauthorised persons away from the work area.
DO NOT use the stand for a purpose it is not designed to perform.
DO NOT operate the stand if it is damaged.
DO NOT use the stand when you are tired or under the influence of alcohol, drugs or intoxicating medication.
DO NOT allow untrained persons to operate the stand.
DO NOT make any modifications to the stand.
Before removing a motorcycle from the stand, ensure that there are no obstructions or persons around the motorcycle.
Keep hands and fingers away from moving parts and support pins.
Always use in conjunction with a suitable rear stand to ensure full stability.
DO NOT operate the stand if parts are missing or damaged.
DO NOT attempt to transport a load on the stand.
When not in use, store in a safe, dry, childproof location.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
2.2.
Specification.
Model No: .....................................................................AFPS1
Minimum/Maximum width: ..................................... 200-300mm
Original Language Version
AfPs1 Issue: 1 - 16/05/12
fig.1
3. ASSEMBLY INSTRUCTIONS
3.1.
The stand is flat packed and requires minimal assembly before first use.
3.1.1. Attach the two side frames to the main frame using six bolts, washers and nuts each side.
3.1.2. slide the two fork support frames into the side frame tops and lock in place with the plastic handled locking clamps. note that they are
handed and should be assembled as in fig.1. below.