Fig.3, Fig.2 fig.3 fig.4 fig.5 – Sealey VS1819 User Manual
Page 2
3.2.
Using the Wheel Balancer
3.2.1. use the balancer on a stable, level surface. If necessary
adjust the feet until the bubble level is central. Screw the leg
nuts tight to the base to secure the legs.
3.2.2. Slide the balancer spindle through the motorcycle wheel
hollow axle and slide a cone onto either end of the spindle so
that the tapered ends enter the wheel bearings. When the
wheel is central on the spindle, secure the cones by
tightening the grub screw in each using a 3mm hex key.
check that the wheel is central on the spindle and firmly
secured by the cones for best results. See fig.3
3.2.3. With the wheel securely on the wheel balancer, gently rotate
the wheel. When the wheel settles, the spot at the bottom of
the wheel is the heavy spot.
3.2.4. now with the heavy spot at the bottom mark the top of the
wheel directly opposite the heavy spot using chalk or
adhesive tape. This is the light spot see fig.4A.
3.2.5. Gently spin the wheel again to ensure that the heavy spot will
again settle at the bottom. (fig.4)
3.2.6. Attach some wheel weights to the rim of the wheel at the
light spot (fig.4A) and spin the wheel gently.
3.2.7. If the light spot falls to the bottom, too much weight has
been added to the wheel. If the heavy spot falls to the bottom,
not enough weight has been added to the wheel. Add /
remove weight as required (fig.5)
3.2.8. Turn the light spot 90 degrees so it sits horizontally with the
heavy spot and observe its movements, if again it falls to the
bottom, too much weight has been added, if the heavy spot
falls, too little weight has been added. (fig.5)
3.2.9. repeat until the light spot and heavy spot are on a horizontal
line through the centre of the wheel. once this has been
achieved the wheel should rest still at any position through
the wheels circumference.
fig.3
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPortAnt: no liability is accepted for incorrect use of this product.
WArrAnty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
InForMAtIon: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7Ar
01284 757500
01284 703534
www.sealey.co.uk
W e b
fig.2
fig.3
fig.4
fig.5
Parts support is available for this product. to obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or telephone 01284 757500.
environmental Protection.
recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
VS1819.V3 Issue: 1 - 19/12/13
Original Language Version
© Jack Sealey Limited