Eton YB550 - Manual (Page 21)

SYSTEM SET CODE TABLE
SHOWN IN
CODE NO. DESCRIPTION DISPLAY
01 * Alarm uses radio station on AL. 1
Page 1, Mem 1
02 * Alarm uses last radio station tuned AL. 2
04 Divide the memories into 4 pages P4: 50
with 50 locations
05 Divide the memories into 5 pages P5: 40
with 40 locations
08 Divide the memories into 8 pages P8: 25
with 25 locations
20 Divide the memories into 20 pages P20: 10
with 10 locations
09 * Set the tuning rating for MW
to 9KHz 9KHz
10 * Set the tuning rating for MW
to 10KHz 10KHz
12 * Set the clock system to 12Hr 12H
24 * Set the clock system to 24H 24H
41
Y B 5 5 0 P E O P E R A T I O N M A N U A L
DEFAULT FACTORY SYSTEM SET CODES USED
FOR NORTH AMERICA
When shipped from the factory, the radio is set up as follows.
Changes can be made via the SYSTEM SET CODE TABLE and
the section titled CHANGING SYSTEM SET CODES, on the pre-
vious page
• 24 hour clock system. Code 24.
• 10 KHz AM (MW) tuning rate. Code 10.
• Eight pages with 25 memories (200 memories total). Code
08.
• 87-108 MHz FM frequency coverage. Code 88.
• 1.5 Volt AA batteries. Code 29.
• Radio alarm uses last station tuned. Code 02.
MONITORING CURRENT SET CODE STATUS
In the set code table shown below, the current status of the
set codes identified with an asterisk (*) can be monitored by
performing a 3 second press of the ‘Sys. Set’ button. The
applicable icon shows briefly in the display window for each
code.
40