Livarno LLL 90 A2 - Manual (Page 53)

Magnifier Lamp LLL 90 A2
English - 51
Power cable
Always hold the power cable by the plug and never pull on the cable itself.
Never place the magnifier glass, furniture or other heavy objects on the mains cable and make
sure it does not get kinked.
Never make knots in the power cable and do not tie it together with other cords. All power
cables should be installed so that nobody can trip over them or be obstructed by them.
Never use adapter plugs or extension cables that do not comply with the safety regulations
applicable in your country, and do not modify the power cord yourself. Any damaged power
cord must be replaced by the manufacturer or authorised customer service. If the power cord is
damaged you run the risk of an electric shock.
Before You Start
Remove the magnifier lamp and the accessories from the packaging.
Fix the magnifier lamp to a desk or workbench using the lamp holder. Make sure the magnifier lamp is
always held firmly in place.
The procedure is as follows:
Fully untighten the knurled screw that’s integrated into
the table screw clamp (E). Guide the table screw clamp
(E) into the fixing pin (D) until it stops moving, as shown
in the diagram. Connect the two parts by fitting the
screw (B) through the hole in the fixing pin (D) and
screwing into the thread on the table screw clamp (E).
Now turn the wing screw (C) a few turns into the
winding on the side of the fitting pin (D). The lamp
holder is now sufficiently assembled for you to be able
to fit it to your desk or workbench. Now turn the knurled
screw clockwise until the lamp holder is firmly and
securely fixed.