Livarno LED PLUG-IN LIGHT - Manual (Page 9)

9 GB
Safety / Start-up / Maintenance and Cleaning / Disposal
To avoid danger of fire and
injury
RISK OF INJURY! Before using the light
bulb always check it for damage. Do not use
the light with a faulty light bulb.
RISK OF INJURY! Check the light regularly
and before every use to see if there is any
damage to the casing and mains plug. Never
use the light if it shows any signs of damage.
RISK OF INJURY FROM BURNS! Ensure
the lamp has been switched off and allowed to
cool before you touch it. In this way you will
avoid the danger of burns. Bulbs give off a lot
of heat around the top of the lamp.
Do not allow the lamp or the packaging mate-
rials to lie around unattended. Plastic film or
bags, Styrofoam etc. can turn into dangerous
toys for children.
Do not look directly into the light source (light
bulb, LED etc.).
The lamp is not replaceable.
This light is not suitable for external dimmers or
electronic switches.
In order to disconnect the light completely from
the power supply, the light must be removed
from the socket.
The light can not be repaired. If the light is
damaged, the product must be disposed of.
Safe working
Use the light in a way where in it protected
from moisture and dirt.
Remain alert at all times and always watch
what you are doing. Always proceed with
caution and do not assemble the lamp if you
cannot concentrate or feel unwell.
Please familiarise yourself with all the instructions
and diagrams in this manual and with the lamp
itself before using it.
Dispose of the lamp if the lamp glass 1 is bro-
ken or cracked.
This article is a wall or reading light. Do not
use it as a nightlight.
Start-up
Insert the lamp’s mains plug 5 into an ordinary
household socket.
Use the ON / OFF switch 4 to switch the
lamp on or off.
Note: Set the desired brightness by turning
the ON / OFF switch
4 clockwise (brighter)
or anticlockwise (darker).
Bend the flexible lamp arm 3 into the desired
position using the lamp pin 2 .
Note: Do not turn the flexible lamp arm 3
completely about itself. Otherwise the mains
lead inside the lamp could be damaged.
Maintenance and Cleaning
CAUTION! RISK OF ELECTRIC SHOCK!
First of all pull the lamp out of the mains socket.
For electrical safety, never clean the light with
water or other fluids, or immerse it in water.
Note:
The device requires no maintenance. The
lighting set cannot be replaced.
Do not use any solvents, petrol or similar. This
would cause damage to the light.
Allow the lamp to cool down completely.
When cleaning, only use a dry, lint-free cloth.
Q
Disposal
The packaging and ancillary packing
consist entirely of environmentally-friend-
ly materials. They can be disposed of at
your local recycling facility.
The symbol of the wheelie bin with the
line through it means that, in the European
Union, the product has to be disposed
of in a separate refuse collection. This applies to
the product and to all components bearing this
symbol. Products marked in this way may not be
disposed of along with normal domestic waste but
have to be handed in at a recycling collection point
for electrical and electronic appliances. Recycling
Introduction / Safety