Livarno Z31999 - Manual (Page 11)

11 GB
material such as cable clamps or conduit to fasten the cable, to prevent
damage to the insulation.
Connect the plug connector 4 from the main unit cable and the solar
cell. Please note these plug-in connector only fit one way.
Screw the two plug-in connectors together using the swivel nut (see
Fig. D).
Start-up
The switch 5 on the main unit 1 (Fig. A) features the following functions:
Position „OFF“: Sensor 3 and spotlight 2 are off. In direct sunlight
the rechargeable batteries are charged by the solar
cell
6 . Use this setting to charge drained batteries
(see „Charging the rechargeable batteries“).
Position „AUTO“: The solar cell charges the batteries in sunlight. The
spotlight will automatically switch on at dusk and off
in daylight. To ensure a long life the LEDs will not be
fully powered in this setting, but only provide approx.
25 % of their full light power (eco mode). When fully
charged, the batteries will provide approx. 8 hours of
light in this setting.
Position „PIR“: The solar cell charges the batteries in sunlight. The
sensor will activate the spotlight at twilight or in the
dark as soon as movement is detected. The light ON
time is preset to approx. 1.5 minutes. If additional
movement is detected during these 1.5 minutes, the
light ON time will reset. In this setting the LEDs will be
fully powered. With the batteries fully charged the
charge on this setting will provide light for a total of
approx. 2 hours.