EverFocus ED100 Series - Manual

IV. Specifications
ED100 ED200
Pickup Device: 1/3 inch B/W interline 1/3 inch Color
transfer CCD
interline transfer CCD
Picture Element: 510x492(/E,EIA) 510x492(/N,NTSC)
500x580(/C,CCIR) 500x580(/P, PAL)
Horizontal resolution: 420 TV lines (EIA) 380 TV lines (NTSC)
400 TV lines (CCIR) 340 TV lines (PAL)
Sensitivity: 0.5 lux/F=2.0 2.5 lux/F=2.0
S/N ratio: Over 48 dB Over 48dB
Electronic shutter: Up to 1/10,000 Up to 1/100,000
Gamma Correction: > 0.45 0.45
Video output: 1.0Vp-p,75 ohm 1.0Vp-p,75 ohm
Power source: 12VDC+/-10%, 12VDC+/-10%,
150mA Max. 250mA Max.
Sync. Mode: Internal Sync. Internal Sync.
Lens Mount: M12xP0.5 M12xP0.5
Dimension: 106mm Dia.x 85mm H. 106mm Dia.x85mm H.
Operating Temperature: -10 o C to +50 o C -10 o C to +50 o C
ED100 Series
ED200 Series
INSTRUCTION
MANUAL
4) Wall Mount, aim to left:
Remove the iron case from the
supporting bracket by using screw
driver to loosen the two screws,
which connect the iron case to the
supporting bracket. Turn the iron
case in 90-degree and mount into
the supporting bracket again by
changing the screw holes in order
to keep the screw indicator on the
top side.
q
Connect the video output of the camera to a B/W monitor
(ED100) or a color monitor (ED200), or other video device
through a 75 ohm type coaxial cable with BNC female
connector at cable extension.
r
Connect the DC+12V regulated power source to the DC12V
Power-in jack with 2mm, center+, outer- plug.
s
Put the dome plastic cover back into the Dome Camera.