ETA Systems EPD10VIEC-CE - Manual (Page 4)

SPECIFIC FEATURES FOR MODELS:
FEATURE
LIGHT SWITCH
EPD11LIEC-CE, EPD11LVIEC-CE, EPD11LOIEC-CE
LIGHT TUBES
EPD11LIEC-CE, EPD11LVIEC-CE, EPD11LOIEC-CE
VOLTAGE DISPLAY
EPD10VIEC-CE, EPD11LVIEC-CE
CIRCUIT BREAKER
EPD10IEC-CE, EPD10VIEC-CE, EPD11LIEC-CE, EPD11LVIEC-CE
POWER SWITCH
EPD10IEC-CE, EPD10VIEC-CE, EPD11LIEC-CE, EPD11LVIEC-CE
(1) FRONT PANEL
EPD11LIEC-CE, EPD11LVIEC-CE,
IEC320 OUTLET
(1) BACK PANEL
EPD10IEC-CE, EPD10VIEC-CE, EPD11LIEC-CE,EPD11LVIEC-CE, EPD11LOIEC-CE
IEC320 MALE INLET
(10) BACK PANEL
EPD10IEC-CE, EPD10VIEC-CE, EPD11LIEC-CE,EPD11LVIEC-CE
SWITCHED
General Operating Instructions:
1. Install unit in a standard 19-inch (48.25cm) rack or in a free-standing position.
2. Connect Power Distribution/Lights Only unit to 230VAC 50/60Hz power source.
3. Plug sensitive electronic equipment into conditioned outlets on back of unit.
4. Move the power switch (#5) to the "ON" position to provide power and protection to the electrical
equipment.
5. For illumination (Models EPD11LIEC-CE, EPD11LVIEC-CE, and EPDLOIEC-CE), pull out/extend the
light tubes (#2) and move the light switch (#1) to either the "HI" or "LO" positions.
IMPORTANT: Be sure the light switch (#1) is in the "OFF" position when the light tubes are recessed
back inside the unit.
6. The digital voltmeter readout (#3) automatically and continuously displays the incoming voltage to
the unit (Models EPD10VIEC-CE and EPD11LVIEC-CE).
SERVICING:
WARNING: Hazardous voltages are present within the unit. Never attempt any maintenance without
disconnecting the power cord.
ATTENTION: Les tensions de l'appareil présentent des dangers. Déconnectez le cordon d'alimentation
avant d'effectuer toute réparation.
VERWARNEND: Gefährlich stromspannung bist im einheit. Test nicht versuch erhaltung ohne ent-
fernend das gewalt schnur.
AMMONIMENTO: Pericolosa voltaggio siamo presentano negli unità. Do non tentative mantenimento
senza allontanando gli potenza spago.