EverFocus EAN800AW - Manual (Page 29)

EAN800A/EAN800AW
29
4.7 EVENT
An event in the camera is when an Event Type is activated and causes certain actions
to be performed. The event type is the set of conditions that specifies how and when
which actions will be performed.
This table describes how to setup action types and event type.
Event Type
Action Type
Alarm Input
Manual
Trigger
Motion
Detection
Schedule
Recording Pre/Post-Alarm
Trigger Alarm x x x
Send Mail notification
x x x
Upload to FTP** x x x
x
Record to SD Card x x x x x
Record to PC*
x x x x x
Network Alarm x x x
Re-trigger x x x
4.7.1 Event
The settings relating to event occurrences such as settings for the event
occurrence, motion, alarm and time mask can be configured on this page.
The "Event " page has 4 tabs: [Event] tab, the [Motion] tab, the [Alarm] tab and
the [Time Mask] tab.
Note: 1. * Record to PC only works when PC and IP camera are connected.
2. **Either Upload to FTP or Record to Network Storage can be selected to
record event video to remote site.
3. Up to 10 event types can be configured in the camera, and up to 3 of these
can be configured to upload images .