Livarno 2592/014L·2592/016L - Manual (Page 8)

8 GB/IE/CY
J Make careful preparations for the assembly
and take sufficient time. Clearly lay out all com-
ponents and any additional tools or materials
that might be required so that they are readily to
hand.
J Remain alert at all times and always watch
what you are doing. Always proceed with
caution and do not assemble the lamp if you
cannot concentrate or feel unwell.
Q
Preparation
Q Required tools and materials
The tools and materials mentioned are not included
in the delivery. The details and values given are
non-binding and for guidance only.
The nature of the material depends on the individual
circumstances on site.
- Pencil / Marking tool
- Screwdriver
- Electric drill
- Drill
- Spirit level
Q
Preparations for use
Q fitting the light
1. Measure up the wall or mounting surface for
drilling the holes. Use a spirit level to improve
accuracy.
2. Mark the two mounting holes a distance of
410 mm apart.
3. Now drill the mounting holes (ø approx. 5 mm,
depth approx. 30 mm). Make sure that you do
not damage any electrical cables during this
operation.
4. Insert the supplied dowels into the drilled holes.
Insert the supplied screws into the dowels and
tighten them. Let them project a distance of about
1.3 mm from the wall or mounting surface.
5. Attach the light using the appropriate mounting
holes 4 or 8 to the screws.
6. Insert the light connector plug of the mains
lead 12 into the light connector socket 1 .
7. Insert the mains plug of the mains lead 12 into
a convenient mains socket. Your light is now
ready for operation.
Q
Connecting several
lights together
CAUTION! Make sure that all under-cabinet lights
are linked together by means of the connecting
cables
7 before inserting the power cable 12 into
the socket.
Note: Make sure that you only connect a maximum
of 3 linked-up under-cabinet lights of the same type
to one socket.
j Install up to three lights of the same model next
to each other. To do so, follow steps 1 – 5 of
the section called “Mounting the lights”.
Note: Make sure that the distance between
the lights is not more than 24 cm.
j Remove the protective head guard 6 by
unscrewing the screw.
j Insert the connecting cable 7 into the con-
necting socket 5 of the light.
j Insert the second connection of the connecting
cable 7 into the socket 1 of the other light.
j Insert the connection of the power cable 12
into the socket 1 of the outer, left-hand light.
j Insert the mains plug 12 into the socket. Your
light is now ready to use.
Q Switching On / Off
j Switch the ON / OFF switch 2 to turn the light
on or off.
Q Directing the light
j Never change the direction of the light while it
is switched on.
CAUTION! DANgER Of bURNS! Do not
touch bulb components or bulbs as they can
reach temperatures > 90 °C during operation.
Safety / Preparation / Preparations for use