Extron Electronics ASA Series User Manual
Page 8
ASA Series • Installation and Operation
ASA Series • Installation and Operation
Installation and Operation, cont’d
2-5
2-4
Furniture mounting
Furniture mount the ASA using the optional mounting kit
(part #70-212-01) as follows:
1
.
Remove rubber feet if they were previously installed on the
bottom of the ASA.
2
.
Attach the furniture mounting brackets to the ASA with the
machine screws provided.
3
.
Hold the ASA with the attached brackets against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
4
.
Drill 3/32” (2 mm) diameter pilot holes, 1/4” (6.3 mm) deep
in the mounting surface at the marked screw locations.
5
.
Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4” of the screw protrudes.
6
.
Align the mounting screws with the slots in the brackets
and place the ASA against the surface, with the screws
through the bracket slots. See the illustration below.
7.
Slide the ASA slightly forward or back, then tighten all four
screws to secure the unit in place.
Figure 2-3 — Mounting the ASA 204 or ASA 304
under furniture
Projector mounting
Projector mount the ASA using the optional mounting kit
(part #70-217-01) as follows:
1
.
Remove rubber feet if they were previously installed on the
bottom of the ASA.
2
.
Attach the projector mounting brackets to the ASA with the
machine screws provided.
3
.
Secure the ASA to a projector mount or other surface by
inserting the mounting bolt through the bracket’s slotted
hole, as shown below.
Digital Projector
Projector
Mounting
Bracket
Ceiling
Mounting
Bolt
P
O
W
E
R
1
2
V
.2
A
M
A
X
S
T
E
R
E
O
IN
P
U
T
S
M
O
N
O
O
U
T
P
U
T
S
B
A
L
U
N
B
A
L
O
N
S
P
A
R
E
3
1
4
2
4
3
2
1
L
Q
U
A
D
A
U
D
IO
S
U
M
M
IN
G
A
M
P
L
IF
IE
R
S
R
A
S
A
2
0
4
L
L
R
R
Figure 2-4 — Mounting the ASA 204 (shown) or
ASA 304 on a projector mount