Livarno Z30894C User Manual
Page 4
6 GB
Directing the lamps / Installation / Maintenance and cleaning
You can vary the height of the pendant lamp over
a wide range by moving the height adjuster
8
.
Release the screw of the cable holder
14
using
the hexagonal key
13
. Retighten the screw
when you have finished setting the height (see
Figs. C–F).
Note: The height adjuster fixes the height of
the light to the desired height (600–1200 mm).
Installation
Note: you will need an electric drill to install the
light.
CAUTION! RISK OF INJURY! Please read
the operating instructions for your drill.
Remove the screws
3
on the side of the con-
nection enclosure
7
.
Remove the mounting bracket
2
from the con-
nection enclosure.
Mark the positions for the drilled holes on the
ceiling using the predrilled holes in the mounting
bracket as a guide.
Now drill the fixing holes.
CAUTION! Ensure that you do not damage
any cables in the ceiling.
Insert the dowels
1
into the drilled holes.
Fix the mounting bracket to the ceiling with the
screws
4
.
Now connect the connection cable of the light
to the mains connection cable (external)
6
by
means of the terminal block
5
.
Note: Ensure that each wire of the mains
connection cable (external) is properly con-
nected in the correct place: live wire, black or
brown = symbol L, neutral wire, blue = symbol N,
protective earth wire, green-yellow = symbol .
Fix the light to the mounting bracket with the
screws.
Unscrew the screws
12
in the lamp fittings
9
.
Insert the energy-saving bulbs
10
and place
the lamp glasses
11
on the fittings. Tighten the
screws again.
Note: Use a clean, fluff-free cloth when you
are inserting a bulb.
Your light is now ready for operation.
Maintenance and cleaning
DANGER TO LIFE BY ELEC-
TRIC SHOCK! Before carrying out any work on
the light, switch the electricity supply off at the fuse
box or remove the screw-in fuses from the fuse box.
DANGER TO LIFE BY ELEC-
TRIC SHOCK! For electrical safety the light must
never be cleaned with water or other liquids, or
immersed in water.
Replacing a bulb
DANGER TO LIFE BY ELEC-
TRIC SHOCK! Before carrying out any work on
the light, switch the electricity supply off at the fuse
box or remove the screw-in fuses from the fuse box.
CAUTION! RISK OF BURNS! Allow the
light to cool down completely.
Note: Use a clean, fluff-free cloth when you are
replacing a bulb.
Use 230 V∼ energy-saving bulbs with an E14
fitting and a maximum power of 9 watt only.
Replace the bulbs in accordance with Figs. A
and B.
Cleaning
CAUTION! RISK OF BURNS! Allow the
light to cool down completely.
Do not use solvents, petrol etc.
Use a dry fluff-free cloth when you are cleaning.
66143_livx_Deckenleuchte_Z30894C_Content_LB4.indd 6
12.07.11 10:59