Livarno LLES B2 - Manual (Page 48)

LIVARNO LUX LLES B2
46 - English
Cleaning / maintenance
Maintenance
The energy-saving outdoor spotlight does not contain any parts that require maintenance.
Replacing the light bulb
The circuit must be disconnected during all work on the energy-saving outdoor spotlight, even
when changing the light bulb! There is a risk of an electric shock!
Only use energy-saving spiral light bulbs with E27 base and a maximum power of 23 watts!
Loosen the 2 screws (1) with a Phillips screwdriver and carefully tilt the front pane (9) downwards.
Unscrew the old/defective energy-saving light bulb (10) anti-clockwise out of the socket. Then screw a
new energy-saving light bulb of the same design (see "Technical data" section) clockwise into the socket.
When doing so, handle the energy-saving light bulb (10) by its base and not by its glass body. The bulb
should only ever be handled with a cloth. Close the front pane (9) upwards now and tighten the 2 screws
(1) again.
Switch on the circuit again.
Cleaning
The circuit must be disconnected during all work on the energy-saving outdoor spotlight, even
when cleaning it! There is a risk of an electric shock!
Ensure that no liquid can penetrate the housing of the energy-saving outdoor spotlight. There is
a risk of an electric shock.
To clean the energy-saving outdoor spotlight, use a soft, dry cloth and never use any solvent or cleaner
that would corrode the plastic materials. Use a slightly damp cloth for more stubborn dirt.
Troubleshooting
The light does not switch itself on
 The motion sensor (8) is not aligned correctly. Correct the alignment.
 The energy-saving light bulb (10) is faulty. Replace it.
 The electrical connection is faulty. Get an authorised electrician to check the electrical connection.
The light switches on and off quickly
 The sensor is disturbed by extraneous light or bright reflective surfaces. Remove the extraneous light
source or the disturbing surfaces.