Livarno 10240 - Manual (Page 13)

14 ES/DE/AT/GB
Safety notes/Assembly/Initial use
■
RISK OF
FATAL INJURY AND
ACCIDENT HAZARD FOR
TODDLERS AND SMALL CHILDREN!
Never leave children unattended with the
packaging material. The packaging material
represents a danger of suffocation. Children
frequently underestimate the dangers. Always
keep children away from the packaging
material. This product is not a toy.
■
Children or persons lacking knowledge or
experience in handling the device or have
limited physical, sensory or mental abilities,
must not use the device without supervision or
instruction by a person responsible for their
safety. Children must be supervised at all times
to prevent them from playing with the device.
CAUTION! DANGER OF INJURY!
Please do not use this device if you find that it
is damaged in any way.
■
Verify all parts are correctly installed. Incorrect
assembly could lead to injury.
■
The LEDs cannot be interchanged.
■
When opening the top, please make sure you
hold the spurts so they will not turn with the
top.
■
This product is treated with a special anti-cor-
rosion coating. Please make sure you treat it
carefully and do not scratch the housing to
prevent corrosion.
Safety instructions for
rechargeable batteries
■
DANGER TO LIFE!
Rechargeable batteries are not intended to
be in the hands of children. Do not leave
batteries lying around. They may otherwise be
swallowed by children or pets. If accidentally
swallowed seek immediate medical attention.
■
EXPLOSION HAZARD! Never
short-circuit and/or open
rechargeable batteries. The battery
may overheat, ignite or explode. Never throw
rechargeable batteries into fire or water. The
batteries could explode.
■
Regularly check rechargeable batteries for
leaks.
■
Skin contact with leaking or damaged
rechargeable batteries could cause chemical
burns; in this case therefore always wear
suitable safety gloves!
■
When inserting the battery ensure the correct
polarity! The correct polarity is shown inside
the battery compartment. The rechargeable
batteries could otherwise explode.
●
Assembly
●
Select a suitable place for
installation
Ensure that
– the motion detector will not be functionally
inhibited at the desired place of installation due
to obstacles or constantly moving objects.
– the light is mounted in a place with direct sun-
light.
– the spotlight is not installed where there are
strong temperature fluctuations, e.g. due to
heating devices.
– the spotlight is installed far away from unnatural
light sources and in southern direction.
●
Mounting the light
Ensure that
– the light is placed with the spotlight head
upwards. Do not install the spotlight in any other
position.
❑
Secure the light to a stable and solid surface
according to the instruction in figure A.
●
Initial use
Note: the rechargeable battery is always factory
installed.
❑
To achieve a long battery life, fully charge the
rechargeable battery in OFF mode (approx.
3x8 hours in summer).
❑
Then fully discharge the rechargeable battery,
(turn on PIR mode approx. 35 x 90 seconds).
❑
Repeat this process once or twice.
❑
If the product has not been used for more than
6 months please repeat this process
LED Solar AussenstrahlerESL-93_CB5.indd 14 7-5-2014 20:42:25