Assembly – Livarno Z29526A User Manual
Page 7
7
GB
Assembly
Assembly
Push the spindle
1
through the follower (see Fig. A).
Note: Please note that the recess in the spindle must point downwards.
Push the drilling template over the spindle
1
and align it vertically (see Fig. B).
Note: Make sure that you use the correct drilling template for the model in question.
CAUTION! RISK OF INJURY! Consult the directions for use that came with your drill.
Now drill the holes for the supporting cams at the places marked.
Repeat this step on the other side of the door.
Remove the cover of the door handle rose
5
by turning the lever rose anticlockwise.
Insert the screws
9
through the prebored holes in the lever rose
6
(see Fig. C).
Now push the door handle roses
6
,
7
over the spindle
1
(see Fig. C).
Using a crosshead screwdriver, turn the screws
9
into the larger holes of the door handle
rose
6
so that that the two door handle roses
6
,
7
are connected to each other
(see Fig. C).
Note: the following working step applies for alternative mounting options only.
Remove the cover of the lock rose
4
by turning the lock rose
2
,
3
anticlockwise.
Secure the door handle roses
6
,
7
into position by tightening the screws
8
using a
crosshead screwdriver (see Fig. C).
Using a crosshead screwdriver, turn the screws
9
into the larger holes of the lock rose
3
so that the two lock roses
2
,
3
are connected to each other (see Fig. C).
Note: the following working step applies for alternative mounting options only.
Place the covers
5
onto the door handle roses
6
,
7
(see Fig. D).
Place the covers
4
onto the lock roses
2
,
3
(see Fig. D).
Note: Ensure that the lever is placed the right way round.
Tighten the set screw on the underside of the lever using the hexagon socket screw key
10
(see Fig. E).
Note:
Regularly check that all joints are intact and regularly re-tighten all screws.