Livarno 3077-025L - Manual (Page 30)

31 GB
Safety notes / Safety advice for installation / Preparation
instruction by a person responsible for their
safety. Children must be supervised at all times
to prevent them from playing with the device.
AVOID DANGER TO LIFE DUE TO
AN ELECTRIC SHOCK!
Before using the product, ensure that the availa-
ble mains voltage corresponds with the required
operating voltage for the device (230 V∼).
Always check the product for damage before
connecting it to the power supply.
Never use the product if it is damaged in any
way.
The connection cable can not be repaired. If
the cable is damaged the appliance should be
disposed of.
Never open any part of the electrical equip-
ment or insert any objects into it.
Protect the product from sharp edges, mechanical
loads and hot surfaces.
Always unplug the mains plug from the socket
before installation, dismantling or cleaning.
Never touch the mains plug or garden light
with wet hands.
CAUTION! RISK OF OVERHEATING! Do
not operate the garden light in the packaging
or if the cable is wrapped around the garden
light.
Only use the light with the accessories which
were delivered with it. Otherwise any warranty
claims will be invalidated.
During long periods of non-use (e.g. holiday),
disconnect the garden light from the power
supply.
Keep the product away from ponds and other
bodies of water. Install the garden light at least
2 m away from water containers. Avoid locations
where flooding could occur after heavy rain.
Only use the garden light outdoors with an
electrical socket, which is fuse protected by a
residual-current circuit breaker (FI or RCD) with
a maximum residual current of 30 mA.
This garden light is splashproof (IP44). This
protection class will only be maintained, if the
electrical socket used also complies with at
least this protection class.
Ensure that the cable of the garden light is not
laid out through areas,in which lawn mowers,
trimmers, shears or similar cutting tools could
be used.
Never pull on the cable of the garden light and
make sure it is routed in such a way that no one
could walk or trip over it.
If you have any questions about the product or
are unsure about any of its aspects, please seek
the advice of an electrical equipment specialist.
Safety advice for installation
CAUTION! RISK OF ELECTRIC
SHOCK! Make sure that you do
not hit electricity, gas or water sup-
ply lines when you are drilling. Check with a
cable detector before drilling if necessary.
Do not attach any other objects to the garden
light.
Avoid excessive bending of the power supply
cable. This can lead to damage of the power
supply cable.
Avoid excessive heating of the garden light.
CAUTION! Only use LED light bulbs with a
GU10 fitting and a maximum output of 3 watt.
Preparation
Required tools and material
The tools and materials cited are not included in
the scope of delivery. This information and these
values are non-binding and are provided for guide
purposes only. The nature of the material is deter-
mined by the individual local conditions.
– Pencil / marking tool
– Cross-tip screwdriver
– Electric drill
– Drill (ø 6 mm)
– Hammer