Zebra Technologies LP 2824 - Manual (Page 30)

Printing on Fan-Fold Media
Printing on fan-fold media requires you to
set the media hangers in position.
1. Open the top cover.
2. With a sample of your media, adjust
the media hangers to the width of the
media. The hangers should just touch,
but not restrict, the edges of the
media.
3. Lock the hangers and guides into
position by sliding the lock forward.
4. Insert the media through the slot at the
rear of the printer.
5. Run the media between the hangers
and through the guides.
6. Close the top cover.
22 980481-001A