Zebra Technologies LP 2824 - Manual (Page 39)

Replacing the LP Print Head (Continued)
Assembly
1. Align the print head to plug the left
and right connectors into the wire
bundles.
2. Slip the ground wire under the right
screw and use a #1 Phillips driver to
tighten in.
3. Slide the print head into one side and
jog it into the other side.
4. Align the pivots of the bracket onto
the posts; then, snap the bracket into
place.
5. Clean the print head with the cleaning
pen.
Reload media. Plug in the power cord,
turn on the printer and print a status report
to ensure proper function.
980481-001A 31