Silvercrest SWKS 2400 D1 - Manual (Page 47)

44 SWKS 2400 D1
GB
MT
1) Lift the kettle off of the base when fi lling it!
2) Press the unlocking button 1 and open the lid.
NOTE
► When fi lling it, hold the kettle upright. This is the only way to read the
markings on the scale 2 correctly.
3) Fill the kettle...
– at least as far as the 0.7 l mark, so that the appliance does not overheat,
– no further than the MAX mark, so that boiling water cannot spill out.
4) First close the lid, then place the kettle on the base 4, so that it sits securely
on the base 4.
5) Now insert the plug into the mains power socket.
6) Press the ON/OFF switch 3 downwards so that it engages.
WARNING - RISK OF INJURY!
► For safety reasons you should not open the lid when the water is boiling or
extremely hot. There is a risk of scalding.
7) The light in the ON/OFF switch 3 shows that the appliance is now heating.
8) As soon as the water is boiling, the appliance will switch itself off , the
ON/OFF switch 3 clicks upwards and the light goes out.
INFORMATION
► This appliance is fi tted with an overheating protector: if the appliance is
switched on accidentally, without any water in the kettle, the appliance
automatically switches itself off .
If, for example due to a non-closed lid the appliance boils dry, the appliance
switches off automatically.
In such cases fi rst allow the appliance to cool down before using it again.