Using of the salt and pepper mill, Adjusting the grinding level – Silvercrest Z31738/Z31738A/ Z31738B/Z31738C User Manual
Page 6
6 GB
If the above instructions are not
complied with, the batteries may
discharge themselves beyond their
end voltage. There is then a danger
of leaking. If the batteries have
leaked inside your device, you
should remove them immediately
in order to prevent damage to
the device!
Avoid contact with the skin, eyes
and mucous membranes. If you
come into contact with corrosive
battery fluids, flush the affected
area thoroughly with clean water
and contact a doctor immediately.
Use
Insert Batteries / Filling of the
salt and pepper mill
Indication: The salt and pepper mill is intended
for peppercorns or coarse salt.
Proceed as follows:
1. Hold the base with the container
6
firmly and
turn the top
1
counter-clockwise (see Fig. A)
until the arrow on the top
1
is aligned with
the symbol on the base with container
6
.
2. Open the bayonet cap by turning and then
pulling it. The remove the top part
1
from the
base with container
6
.
3. Pull the motor
3
carefully off the base with
container
6
.
4. Insert 6 new batteries type AAA 1.5 V
(LR03).
Indication: Pay attention to the right polarity.
This is shown in the battery compartment.
5. Fill up the base with container
6
with pepper-
corns or coarse salt. The best result will be
achieved when filling the base with container
6
up to 75 %.
6. Put the motor
3
back on the base with contai-
ner
6
. Be sure to place the notch on the motor
marked with a white arrow into the respective
protrusion on the base with container (see Fig. B).
Indication: Please make sure that the contacts
4
,
5
face each other (see fig. A).
7. Put the top
1
back on the base with con-
tainer
6
.
8. Hold the base with container
6
firmly and
turn the top
1
clockwise (see Fig. B) until the
arrow on the top
1
aligns with the symbol
on the base with container
6
.
Using of the salt
and pepper mill
Pull off the aroma seal cover
7
from the bot-
tom of the base with container
6
before use
(see fig. B).
Please keep the switch
2
pushed to activate
the salt and pepper mill. The bulb
9
on the
base of the salt and pepper mill will then be
simultaneously activated.
Adjusting the grinding level
Turn the adjustable screw
8
clockwise to
receive a finer grinding level (see fig. C).
Turn the adjustable screw
8
anticlockwise to
receive a coarser grinding level (see fig. C).
Turn the top of the device and press the switch
2
to remove residues from the grinding mechanism.
Note: Choose a coarser setting if the grinding
mechanism stops rotating when you are using a very
fine setting. If the grinding mechanism still refuses to
rotate, then it may be choked or blocked. Unscrew
the adjustable screw
8
and loosen the grinding
mechanism. Release the stuck pieces by shaking the
grinding mechanism, then tighten the adjustable
screw
8
again.
103639_silv_Salz_oder_Pfeffermuehle_Content_PL_HU_SI_CZ_SK.indd 6
15.08.14 12:29